Having problems with your Digital Cameras ?

Lens is stuck out and not going back in keep getting lens error restart


Answers :

Fixing a Lens Error on a Digital Camera
\012


\012

This has to be THE most common failure mode for a digital camera. Some common error messages that might show up on the LCD's of cameras with this problem include "E18 lens error", or "lens error, restart camera". Some cameras might show nothing at all, but merely make a beeping noise as the lens goes out, then in, then the camera shuts off. Sometimes the lens won't even move.
\012

The problem is actually quite common throughout all camera brands. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended. Believe it or not, one BIG contributor to lens errors is using a camera case. Sand, gunk, case fibers, etc... accumulate at the bottom of the case. These materials love to cling to the camera by electrostatic build-up from the camera rubbing against the side of the case (especially those cases with soft fibrous intreriors). Once these materials work their way into the lens mechanism, that's all she wrote. I have many Canon's, and NEVER use a case for this very reason.
\012

A camera owner that suffers this problem may have no recourse for having the camera repaired. Many camera makers will not honor repairing this problem under warranty as they claim it is due to impact damage to the camera, or sand or debris getting into the lens gearing mechanism (neither of which is covered under warranty). The quoted repair cost is usually close to or more than what the camera is actually worth.
\012

Fortunately, about half the cameras that suffer this failure can easily be fixed by one of the following methods. None of these methods involve opening the camera, although some have potential to cause other damage to the camera if excessively done. If the camera is still under warranty, before trying any of these, please please first contact your camera's maker to see if they'll cover the repair, or to determine how much they'll charge for the repair. Who knows, you might get lucky. But if they quote you a number that's higher than the value of your camera, you may want to consider the following methods.
\012

The methods are listed in the order of risk of damaging your camera. Thus make sure you try them in the listed order. And remember, these fixes (especially #6 and 7) should only be considered for a camera that's out of warranty, who's cost of repair would be excessive, and would otherwise be considered for disposal if unrepaired:
\012

Fix #1: Remove the batteries from the camera, wait a few minutes. Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera on. If that didn't work, try pressing and holding the Function or OK button while turning the camera on.
\012

Fix #2: Remove the batteries, then remove the memory card. Then install new batteries, and turn on the camera. If you get an Error E30, it means you don't have a memory card installed, so turn it off, slip in the memory card and turn it on one last time.
\012

Fix #3: Insert the cameras Audio/Video (AV) cable, and turn the camera on. Inserting this cable ensures that the camera's LCD screen remains off during the start process. Thus extra battery power is available to the camera's lens motor during startup. This extra power can be useful in overcoming grit or sand particals that may be jamming the lens. If the AV cable doesn't fix the lens error by itself, consider keeping this cable installed while trying fixes 4, 5, and 7 as a means to provide extra help to these fixes. But note that I DON'T recommend keeping the cable installed during Fix 6 as you may damage the AV port while tapping the camera. Reinsert the cable only AFTER tapping the camera.
\012

Fix #4: Place the camera flat on its back on a table, pointed at the ceiling. Press and hold the shutter button down, and at the same time press the power-on button. The idea is that the camera will try to autofocus while the lens is extending, hopefully seating the lens barrel guide pins in their slots.
\012

Fix #5: Blow compressed air in the gaps around the lens barrels with the idea of blowing out any sand or grit that may be in there jamming the lens. Other variations include blowing with a hair dryer in "no heat" setting, or sucking the gaps with a vacuum (careful with this one).
\012

Now we're entering into the realm of potentially damaging your camera in conducting the fix. There is definitely some risk here, so take care when conducting the following two fixes.
\012

Fix #6: Repeatedly tap the padded/rubber usb cover on a hard surface with the intent of dislodging any particles that may be jamming the lens. Other variations include hitting a side of the camera against the palm of your hand. A lot of people have reported success with this method. HOWEVER, there is also some potential for damaging or dislodging internal components with this method, such as unseating ribbon cables, or cracking LCD screens.
\012

Fix #7: Try forcing the lens. More people have reported success with this method than with any of the other methods. HOWEVER, there's obviously some potential for damaging your camera by using this method. Variations include gently pulling, rotating, and/or twisting the lens barrel while hitting the power button. Attempt to gently straighten or align the barrel if it's crooked or twisted. Another variation includes looking for uneven gaps around the lens barrel, and then pushing on the side of the lens barrel that has the largest gap (note pushing the lens barrel all the way in is NOT recommended as it may become stuck there). While doing any of the above, listen for a click that indicates that the lens barrel guide pins may have reseated in their guide slots. If you hear this click, immediately stop and try the camera.

Repair Help & Product Troubleshooting for Digital Cameras

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lens error lens is stuck out and not going back in, keep getting lens error restart camera


If the lens is stuck out then you will find it is usually one of a few reasons.\015\012\015\0121. Check the batteries. (obvious I know).\015\0122. The camera has been dropped or knocked.\015\0123. The camera has grit or dirt i ... Canon PowerShot A460 Digital Camera

Lens is stuck out and not going back in keep getting lens error restart


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Digital Cameras

Stuck lens How can get the lens to go back in it reads lens error and restart camera


The lens needs to be repaired or replaced. Could be one of several problems, sand, impact damage, broken gears. A professional camera repair shop should be able to do this for a reasonable price. ... Canon Digital SD900 / IXUS 900 Ti Digital Camera

I have a canon powershot SD 1000. The lense is stuck out. When I go to turn on the camera it says "lens error, restart camera". I don't know how to do this or how to get the lens back it. Help?


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Canon PowerShot SD1000 Digital Camera

Keep getting lens error, lens wont go back in, it is stuck


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Digital Cameras

Lens error, restart the camera. How to retart. The zoom lens projected is not getting back again When the camera was on, the zoom lens cameout and got struct and not going inside. we get a instruction as ''lens error, re start the camera'' W e dont know how to restart and tried but failed. we need solution. We are unable to use the camera.


Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or ... Digital Cameras

My canon camera Ixus 8515 has an error when turning on (after some 'stuck' noises) that reads 'lens error, restart camera'. The lens is not retracting. The camera has not been dropped. Was working fine one minute, then camera appeared out of focus the next. When I turned camera off then on again, error appeared. Lens won't go back in. Have not tried forcing it as yet.


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you wi ... Canon Digital SD900 / IXUS 900 Ti Digital Camera

My son dropped my Sanyo camera, and now the lens is stuck out and when I turn it on it says "system error." I can't get the lens to come all the way out or go back in. It's stuck halfway and I can't do anything with it.


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digital camer ... Sanyo Xacti VPC-S60 Digital Camera

When I turn on my camera, It tells me Lens error and that I should restart my camera. Don't know how to restart it except turn it off and I get the same message. The lens doesn't go back in when I turn it off. Pleasr help. I have a wedding this weekend thank you sue


Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. O ... Canon Powershot A2000 IS Digital Camera

When I turn on my camera It tells me Lens error and that I should restart my camera. Don't know how to restart it except turn it off and I get the same message. The lens doesn't go back in when I turn it off. Pleasr help. I have a wedding this weekend thank you sue


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \015\012probability is t ... Canon Powershot A2000 IS Digital Camera

Lens is stuck out and wont go back in. When the camera is turned on message on back screen says "lens error, restart camera"


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Canon Digital Cameras

First my lens was stuck. After releasing it, the lens keeps coming out and going back in, Than gives an error message saying 'turn camera off and back on again' but this doesn't help. What to do?


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digital camer ... Sony Cyber-Shot DSC-T1 Digital Camera

When I turn on the camera, it says "lens error, please restart". The lens doesn't open when you turn on the camera- it is like it is stuck shut. you can manually force it open, but it won't go automatically, and so it keeps on giving the error messages.


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you wi ... Canon PowerShot SD600 Digital Camera

Lens error,,restart camera.,,the lens wont go back in ,,and the camera will not work,,,its like the lens is stuck,,,can any one help please!!!


Did you try replacing the batteries? If that's not the problem, then it might just be stuck. Look to see if the lens is a little crooked. If it is, try to gently \015\012straighten it. If it still won't retract, try to gently push i ... Canon PowerShot SD750 / IXUS 75 Digital Camera

I am getting a lens error and then its says to restart camera..The lens is out and will not go back in..how do I fix this.. This camera is a powershot a470


... Canon PowerShot S2 IS Digital Camera

Lens error 0x0211 and lens will not go back in, camera will not turn on, keep getting that message and then it turns off. the camera is praktica model DPix 1000z.


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Digital Cameras

Canon Powershot SD 600 keep getting "lens error, restart camera" and the lens is stuck.


Try these procedures. ... Canon PowerShot SD600 Digital Camera

I dropped my camera today, and since then, I can't power down correctly. The lens will not go back in, and I can't use the camera at all, not even to view pictures already taken. I get a message that says lens error, restart camera. Can you help?


Try wriggling the lens LIGHTLY as you power off and see if you can get it to go in.\015\012If that doesn't work, I hope you have insurance, as it will need to go in for repair.\015\012It is damaged. Sorry for the bad news. ... Canon PowerShot SD600 Digital Camera

The lens is stuck and not retracting - keep getting a msg 'lens error pls restart camera' Does not fix itself even after restarting.The camera model is IXUS 11015 with 12.1 mega pixels


Stuck lenses are probably the most common \015\012reason that compact digital cameras get thrown away, but there's a fair \015\012chance of recovering use of your camera againThe fault is \015\012commonly caused by dirt or grit bloc ... Canon PowerShot A75 Digital Camera

Lens error, restart cameraI turn on my camera, and I get an error message stating Lens error, restart camera, the lens is open and will not retract, I have removed the battery and tried to restart. It will not go beyond the lens error message


This is probably THE most common problem with digital cameras. Try these procedures. ... Canon PowerShot SD850 IS Digital Camera

Lens error, restart cameraI turn on my camera, and I get an error message stating Lens error, restart camera, the lens is open and will not retract, I have removed the battery and tried to restart. It will not go beyond the lens error message


Try these procedures. ... Canon PowerShot SD850 IS Digital Camera

Lens error restart camera but it just switches off i keep getting a lens error restart camers error i turn it off and on but get the same error


This is probably THE single most common failure among digital cameras. There's a halfway chance of fixing it yourself, described here: http://camerarepair.blogspot.com/2007/12/fixing-lens-error-on-digital-camera.html ... Canon PowerShot SX100 IS Digital Camera

Lens error, restart camera telephoto lens is stuck in zoom position and won't retract, so when i turn on camera, screens says "lens error, restart camera", but it won't restart...just keep coming up with same error message


Hello mnickoliThis is a fairly common error especially with the A560.This either means that something is jamming the lens , or that the\015\012lens sensor is faulty. This is a very , if not the most common problem\015\012with modern digit ... Canon PowerShot A560 Digital Camera

Hi how do i fix a lens error restart camera error on my canon powershot sd750 so my camera can go back to normal and the lens could go back in?


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\012\ ... Canon Powershot A2000 IS Digital Camera

The camera lens is halfway out and will not go back in. We keep getting the error message E18 on the screen.


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digital camer ... Canon PowerShot A520 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3457 seconds