Having problems with your Digital Cameras ?

I have a Caplio R4 camera which has recently become out of focus. The zoom appears to still be working fine and the shutter closes properly but the LCD is all blury. The only thing I remember doing to loading a new SDHC card and trying to format it. Please help


Answers :

Please try and remove off the SD card and try a scan on the PC . Remove the battery for sometime and load another card and switch over the camera. If the fault appears then check the pictures shot on the camera on the PC, if the pictures are blurred or out of focus then shut down the camera, place the lens on your palm and tap while you switch on and off. Repeat few times to observe if the fault clears. if not the fault can be in the focus or a failure of the CCD in the camera.
\015\012If pictures shot are seen perfectly on the PC then it is possible that the LCD is faulty.
\015\012Please counter check on this to confirm with pictures taken and tested.
Repair Help & Product Troubleshooting for Digital Cameras

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Caplio R4 camera which has recently become out of focus. The zoom appears to still be working fine and the shutter closes properly but the LCD is all blury. The only thing I remember doing to loading a new SDHC card and trying to format it. Please help


Please try and remove off the SD card and try a scan on the PC . Remove the battery for sometime and load another card and switch over the camera. If the fault appears then check the pictures shot on the camera on the PC, if the pictures are blurred ... Digital Cameras

I bought a replacement LCD screen, but when I remove the back case, the connector for the LCD is *under* the silver plate. I can't figure out how to get the plate off to reach the connector so I can install the new LCD. I've removed screws, but it still lifts only halfway. Is there some kind of trick I'm not seeing to get this thing open?


Hi dear Sir fishiemnma, remove the broken LCD display lifting it up carefully of retention plate.You did not make? will you have access to the connector afterwards.Regards ... Nikon Coolpix S3000 Digital Camera

Lcd display not working.nikon p500 went into watrefalls.. after putting it into ricebag for few days ( service center guy told it can t be done) after few days i could switch on camera , and could take pictures from view finder, lcd display seem to be not working.. any thing advisable to make work? can i go for new lcd, if so how much it would cost..


Yes you can replace it You must to do the decission replace LCD vs New camera. Call or go to NIKKON and ask them where is difference in cost Sometimes replace is cheaper that to buy. Other is better to buy that replace specially in USA.God bless ... Digital Cameras

I bought a replacement LCD screen for my Nikon S3000 camera, but when I remove the back case, the connector for the LCD is under the silver plate. I can't figure out how to get the plate off to reach the connector so I can install the new LCD. I've removed screws, but it still lifts only halfway. Is there some kind of trick I'm not seeing to get this thing open?


Hi dear Sir, contact uscamera.com to obtain a repair manual.Regards ... Nikon Coolpix S3000 Digital Camera

The lcd screen on my camera cracked, and it had a dark spot on it. I bought a new screen to replace it. I replaced it, but the only thing that happens its the the camera lens opens and everything stops. The lcd screen doesn't come on, and the camera wont power off. is there something that i am doing wrong, or that I need to do to get this to work? thanks, Lavoia


Maybe you installed the LCD screen wrongly and it doesn't respond if not properly installed. ... Digital Cameras

I have a fine Pix S700. whenI downloaded my first xdPicture card from the camera to the PC if worked fine. Now when I take a picture and play it back the LCD monitor is black. I instlled a new xpPixt card, same thing, a black LCD. Eachtime I take a picture the counter goes down by one. Need Help


You Fuji Camera S700 has problem with CCD Imager Sensor and this part needs to be replaced.Please contact Fuji Support to locate nearest Fuji service cen ... Digital Cameras

I have a Gateway computer with Vista program on it. I have been able to load my pictures from myCX7310 Kodak until now. I don't see a way to do it now. There are no directions as to what happened to adding pictures. Some thing seemed to have disappeared. Is it the Vista program ? How do I load my new pictures? Thanks. Evelyn Connelly


Try connecting the camera to a diffrent usb port and it should recognise the Camera atthat point of time u can click on start goto computer and in computer u will see a removable disk option u can download the pictures from there if it doesnt show up ... Digital Cameras

I have a new (Dec., 2009) D90. This morning I discovered that I had an "Err" message and a "CHA" message. Both were on the LCD panel on the top of the camera. I was not able to turn the camera off, and the only way to turn it off was to take out the battery. Upon reinserting the battery, everything appeared normal, but after taking one shot the problem reappeared. The interesting thing was that I took the camera body to a Nikon certified shop in New York, and they tried it with a different lens,


The Nikon user manual says on Page 256 that the ERR message indicates a camera malfunction and to clear it, you must release the shutter. \012\012 I have found on my D-90 that I can usually release the shutter by turning the camera off and ba ... Nikon D90 Digital Camera with 18-105mm lens

3040 Issues I just got a 3040 and had a question about a couple of things I noticed (I've never owned an Olympus digital camera). When the camera is powered up, the noise from the lens coming out sounds awful (like a grinding noise). Is this normal? It zooms in/out without any problems but it just sounds odd. It just doesn't sound smooth... Is a stuck pixel on the LCD enough of a reason to return it for a new one? The pictures do not show the stuck pixel but I am concerned that a new and e


A stuck pixel on the LCD is quite common. I have one on my 2020z; lot of people here would tell you the same thing. Long as it's just one, I wouldn't bother trying to get new camera.\015\012\015\012Far as the lens extension sound: It is a little loud ... Olympus Camedia C-3040 Zoom Digital Camera

I got a new computer and I lost my CD to download my camera to my computer to load pictures. Is there anything i can download offline that instals the same thing as the CD did that came with the camera?! or do I have to get a new CD?!


You can download the current versions of Nikon software from Nikon's web site at http://support.nikontech.com/app/answers/detail/a_id/61 The best way to download pictures from your camera to your computer involves removing the memory card ... Nikon COOLPIX S230 Digital Camera

Tried cleaning my Sony gv-d200 vcr with a new Dynex® - 8mm Head Cleaner Model: DX-DA100511 it didn't work. It just got jamed, and would not load. After 3-1/2 hour I got it out. Went back to the store and got a new one. Same thing. I looked for a Sony 8mm Head cleaner Model v8-25cld, but their hard to find. Is there another head cleaner that will do the job?


... Digital Cameras

My camera out of no where has a problem loading to take a pic... it turn on stays on the blk cyber shot screen and opens lens then stays there and then i get a dialog box showing turn power off and on again i do and it does the same thing it s brand new no water damage nothing went from working to not


... Sony Cyber-shot DSC-W170 Digital Camera

Fuji s5000 every thing works except when you look through the lens or lcd window it is milky and shows red readings i have tried new batteries and this work for a short while


... Fuji FinePix S5000 Digital Camera

Hello, re: CANNON POWERSHOT A 85 camera is not even 2 yrs. old yet and it started to have streaking lines in the lcd monitor now it does not show any view at all. it is completely black when trying to take pics. put brand new cannon in and to no avail. this thing cost over $225! spoke to several people they had the same problem with the cannon powershot a 85. what is the remedy? i am sure you have had many complaints according to the internet.


... Digital Cameras

I have a Cannon camera model Power Shot A80, AiAF #7021042214. My problem is that on the LCD monitor I get a verity of color swirling across the screen and when I down load to my computer it is the same thing. Once in a while it will clear up and I can then take good pictures. Help! Tom Van Mater


See the manual or user guide for take a batter picture for your problem u have reset ur camera in factory setting ... Canon Digital Cameras

The camera was working fine. I imported the pictures to Picassa succesfully and turned the camera off. I then went to take new pictures and all I get is a black LCD screen and when I load into Picassa the pictures are all black. The camera seems to work well, zoom, flash menu all seem normal except there is no picture. Can it be fixed and would it be cost effective?


The CCD is bad or the Iris is shut stuck. If it's the Iris just stuck, it might just have moisture - leave the camera in a dry place for a day. If it's the CCD - pretty much "kiss-it-good-bye". To replace the CCD is expensive - get a new camera. ... Digital Cameras

My canon rebel xsi was working a month ago. Today I took it out from the case and found it was not reading the card (8gd transand). It had been working fine until last time I used it mid of April. Thought it was a card problem, I went out to buy a new one (8gb sdhc), put it in and it asked for reformat. Proceed to reformat the card, but it says it can't reformat it and ask to change the card. Put in the old card (which was loaded with picture I previouly took), it asks the same thing. I'm 100% s


The reader in the camera has gone bad. You can get it repaired by anyone who fixes camera's or by sending it to Canon which will cost you more then finding someone in your home town that repairs cameras. Just FYI the repair is somewhat costly roughy ... Canon Digital Rebel XTi Digital Camera

Every time i try to download my new pics a thing pops up saying program is already running and wont let me down load


Consider NOT connecting your camera to your computer.\012\012\012The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to ... Canon PowerShot A540 Digital Camera

My Canon Rebel has stopped importing pix properly, despite being quite new. It displays pictures ok, we get to Windows explorer to view them as thumbnails as normal(with 0 kb size!), which Windows cannot open or view, or drag or copy over. On the camera side I can zoom into the image on the LCD display. 2 memory cards and the same thing...


Try going to the Canon website for your country. It may be a driver problem in that the driver to download your photos is either out of date or incorrect for your camera. I had a very similar problem with my EOS 350D in that it would not import pictu ... Canon Rebel XT / EOS 350D Digital Camera

Polaroid digital camera i832 was working fine through USB cable. Received an Ipod shuffle for Mother's day, downloaded the software, loaded my Ipod and now my camera doesn't work. I'm think it's the Itunes software, because that's the only new thing that's been downloaded and the camera worked previously to that. The removable disk drive (F:) recognizes it, but wants me to "format disk". Under the device manager, disk drivers, there is a Maxtor 6Y080L0 listed and my camera. I don't think the Max


The maxtor is your computers hard drive- the computer will also see your ipod as a hard drive-leave everything alone and use a memory card reader to transfer pics from card to computer-no software plug n play ... Polaroid i832 Digital Camera

Bought in 2005 and have enjoyed its marvelous pictures. I put new batteries in, checked the ''all but empty card'' by seeing if it would download to computer; it did, no problem there. But, when I turn on the camera today the image in the camera's LCD shows what it sees with a quarter inch white bar at the top and flickers with a slow roll of the image viewed. The colors are also slightly off. I do not remember dropping the camera. I noticed that the screw plate on the bottom edge had one


If it is Canon A75 camera then its known problem of bad ccd iamger and canon will repair it free of cost.Click ... Canon PowerShot A75 Digital Camera

I just purchased a new smsung model S630 and i never received a manual for it. I have been able to do some things but now the camera says MEMORY FULL and i do not know what to do. I have already down loaded the 9 pictures i took to the computer but it still comes up MEMORY FULL.


When you "Download" to the computer, you actually copy them to the computer, they will still be in the memory, check the camera menu for a delete process, and delete them and you will be good to go. ... Digital Cameras

Sony DSC-W80 6 month old DSC-W80 needed LCD flex reattached. Done under warranty. 11 Months later, same thing. Out of warranty repair $68 + S&H. Too Much New now $119. I want to try to repair myself. Need take apart instructions.


... Digital Cameras

I shattered the lcd screen on my coolpix S630. I purchased a new lcd screen for my camera type/style. I now need step by step instructions on how to replace the old lcd with the new lcd.


Hello and welcome to FixYa.\015\012\015\012unfortunately I have not taken this camera part myself as I don't own it and it has not come up.\015\012\015\012\015\012Basically what you need in taking apart a camera, is a set of precisi ... Digital Cameras

Tried to down load pictures from my new A630 to my existing Cannon utilities program. The program would not open. I then took the new Solutions disk and installed the programs. /when the installation was complete I tried to down load the pictures again. When I attemted to down load I got an error message the Zb Module had encountered a problem and had to close. I got the same response when I tried to open the Zoom browser. I tried from the shortcut and by going direct to the programs.


SteveJudy, Uninstall all utilities related to the Camera in question (via add/remove programs within control panel), re boot, and install the utility from the disk that came with your new A630 and give it another try.Good luck. ... Digital Cameras
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1855 seconds