Having problems with your Digital Cameras ?

I have dynex monitor scan#2297LC22K+46H08173....LOT##180565XHT090466. This for a surveillance system w/ 4cameras,also w/dynex remote rc 401-oa.do you have manual for the above, system is set-up for 4cameras, I do not know how to operate remote to show all camera locations.



Answers :

L couldn't find any information on the monitor scan number, but the remote that picks the different channels should be operating the control box, where the cameras are plugged in to. I've never had this type of unit, but I suspect that the control box picks each camera, and has to select that camera with its own remote, not the tv's, so re-enter your question with the system number, if different than scan#2297...etc., and perhaps we can find more information.
\015\012If you enter the unit's model number at Retrevo.com, you may be able to find a free .pdf manual- they have many.
\015\012Good luck, and hope this helps.
Repair Help & Product Troubleshooting for Digital Cameras

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have dynex monitor scan#2297LC22K+46H08173....LOT##180565XHT090466. This for a surveillance system w/ 4cameras,also w/dynex remote rc 401-oa.do you have manual for the above, system is set-up for 4cameras, I do not know how to operate remote to show all camera locations.


L couldn't find any information on the monitor scan number, but the remote that picks the different channels should be operating the control box, where the cameras are plugged in to. I've never had this type of unit, but I suspect that the control ... Digital Cameras

Bought new remote for my nikon D80 but it does not seem to operate the shutter - is there a specific setting (remote came without instructions


Set the release mode on the camera to one of the remote modes.Look in the camera manual under either "Shooting Mode" or "Release Mode." ... Nikon Digital Cameras

Sanyo VPC-SX500 I bought a new iMac and cannot get my photos to download from my old Sanyo VPC-SX500 camera.  I have the set up CD but when I try to use it I get the message You can't open the application because the Classic environment is no longer supported.  The CD does say that MGI Photosuite SE for Macintosh is on there.  Do I just need an upgraded set up CD?  One that the newer iMac operating system will run? Tracy


Your iMac came with iPhoto. You should be able to download your photos with it. There is a freeware app that may work as well. You can find it here: http://www.bluechillies.com/details/20859.html ... Sanyo DSC-SX500 / VPC-SX500 Digital Camera

I cannot operate my Koolertron PIXEL RW221/RS1 remote shutter release with my DMC-GF1 camera.


... Panasonic Lumix DMC-GF1 Digital Camera with 14-45mm lens

Software Issue I have a ViviCam 3826 camera, which to download uses Windows 98 or XP operating systems. I have converted to a Vista operating system and am wondering if there is software out there that I can download to my computer to allow me to download my pictures.


You don't need any special software.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via ... Vivitar ViviCam 3826 Digital Camera

Mr. I have an c-740 Ultra Zoom that I receved as a gift 2 years ago It came with camedia Master 4.1 I installed on my computer I had at that time with no problems that computer used windows 2000 operating system. I now have a computer with Vista operating system and I am experiencing diffuclties is this compatable with Vista? can I down load updates? Please Help. thank-you [email protected]


Not compatable with vista. ... Olympus Camedia C-740 Ultra Zoom Digital Camera

Have windows 7 operating system. my rebel xt is from 2004 and not compatible - no canon software... what card reader can I get that would be compatible with my operating system?


The card reader package lists what systems it is compatible with. ... Canon Rebel XT / EOS 350D Digital Camera

I have the gtmax universal infrared wireless IR remote control for digital slrs. I followed the instructions to set it up with my Nikon D80, but it doesn't seem to be working. What are the step by step instructions to set up the remote with a camera? Maybe I'm missing something.


... Digital Cameras

When I try to install the software for my Samsung Digimax S500 digital camera (using Windows XP operating system), I get the prompt saying that the software "has not passed the microsoft logo testing for compatibility with Windows XP", even though the disk indicates the software is for Windows XP as well as earlier operating systems. How do I get around this?


The prompt should give you the option to continue anyway. ... Samsung Digimax S500 Digital Camera

The flash on my Nikon D3000 won't pop up (regardless of the setting) and when I go into "Shoot" (from the guide menue) and then into "Easy Operation" the camera is set at No Flash but I'm not given the option to change the setting and says "The camera is now on "Auto No Flash Mode" but doesn't give me an option to change the setting there either. Can you help?


... Nikon D3000 Digital Camera

Trying to get a remote system working on my D60?


You need to set the release mode to one of the remote modes. The quick-response remote mode fires the shutter when you press the shutter release button on the remote. The delayed remote mode gives you two seconds to hide the remote behind your back b ... Canon PowerShot EOS D60 Digital Camera

My question about the operating system


If you are asking which came first: the operating system or the programming language, then the answer is simple. The programming language because the OS is a porgram lust like all other programs.\015\012If you need more specifics about early pr ... Olympus FE-230 Digital Camera

Settings memory Whenever I change the batteries, the system settings revert back to their default settings. I'm assuming that there must be a small battery somewhere in the camera. Do you know what disassembly procedure I must follow to get to that battery?


There is no other battery for your settings, as indicated by the manual if you leave your camera for more then 1 hour without batteries (or dead batteries) you will loose all you settings.\015\012\015\012Unfortunately is the way this came ... Olympus Camedia C-750 Ultra Zoom Digital Camera

I HAVE A NIKON SB-800 FLASH UNIT AND I WAS TAKING PHOTOS OF RACECARS AND SOMEONE ELSE THERE HAD FLASH UNITS SET UP ON BOTH SIDES OF THE RACE TRACK WITH REMOTES, AND NOW MY FLASH WONT LIGHT UP AND THE SCREEN READS MRPT A RPT AND UNDER THAT IS BRPT CRPT AND OVER TO THE RIGHT SIDE IT READS CH4 STBY 80 AND BELOW IS F11 XM ZOOM 14MM WHAT DO I NEED TO DO TO CANCEL THIS SETTING AND GET BACK TO MY REGULAR SETTING AND HAVE


Hey ljthomp6_30,\015\012 I would just reset the flash back to the manufacturers default setting, which is done by pressing the mode button and the on/off button simultaneously for about 2 seconds. Keep in mind this wi ... Digital Cameras

I use a Quantaray lens af ld 70-300mm 1:4-5.6 tele-macro(1:2)@62 with my Canon eos Digtal Rebel xti. I have used the camera and the lens together very well for about a year and a half. Just recently with this lens set aat normal and the camera set at af(auto focus)the lens trys to focus and will continue to search for the correct focus setting with out taking the picture. Also the lens appears to be darker when I look through the viewer. I have a Canon EFS18-55mm lens which is operating correctl


... Digital Cameras

Need to dwnload a English language operating System


You can get this english version from link below:\015\012\015\012http://www.olympusamerica.com/cpg_section/cpg_support_product.a ... Olympus FE-310 Digital Camera

1- How do you set ISO? 2- How do you set aperture and shutter manually? 3-How do yu open the blue "operating instructions" disk?


The ISO is set in the camera menu. You can't set the aperture and shutter manually...this is basically a point-and-shoot camera with some nice features. You should copy the disc to your computer and then open it from there by double-clicking on it. ... Panasonic Lumix DMC-LZ2 Digital Camera

Camera shuts down after shutter button is pressed. It shuts down halfway through the shutter operation. Everything else works fine-reviewing pictures, settings in menu, focusing, exposure settings etc. The camera focuses ok when the shutter button is half pressed then when you press the shutter button fully, the mirror goes up, shutter appears to open then the camera shuts down with no power. Only way to get mirror etc back to normal is to remove the battery and refit. When camera is turned b


... Canon EOS 40D Digital Camera

KODAK C190 DIGITAL CAMERA...iVE CHARGED THE BATTERIES FROM 6PM TO 630PM NEXT DAY. I INSERT THEM IN THE CAMERA AND THE CAMERA WILL NOT TURN ON. WHAT AM I DOING WRONG? i RETURNED THE FIRST ONE FOR THE SAME REASON. SO I DONT THINK ITS THE CAMERA. I PLACED THE BATTERIES IN A REMOTE TO SEE IF IT WOULD WORK AND THE REMOTE OPERATED. ANY THOUGHTS..PLEASE. THANKS


Pls. use lithium batteries Ni-Mh or rechargeable Batteries (2000 M.Amp or higher).\015\012Here are the steps:\015\0121. Make sure you will install a new or fully charged battery/batteries into your camera.\015\0122. Clean the batter ... Kodak Easyshare C190 12MP Digital Camera with 5x Optical Zoom and 2.7-inch LCD

I have a Kodak Z1015IS, about 16 months old, that has not been subject to any type of liquid or damage. One day I went to use it and I was not able to adjust any of the PASM settings (i.e. f-stop, shutter speed, etc.). All other hardware and menu systems work just fine, it is just that the settings are locked in place (at the levels of my prior use). I've tried updating the firmware, formatting the internal memory, and removing the battery with no luck. Just spent time with Kodak, and a


Kodak is right, they don't release any type of technical information about there products to the user, the only ones that can get parts or tech support are the repair centers, sorry but that is just the way they do things, this is not just Kodak it i ... Kodak EasyShare Z1015 IS Digital Camera

Nikon d40 am having a plobrem with the auto focus and the camera won't take pictures whe on auto settings. if you focus manually and the subject is clear , the camera will operate, but will not operate when the subject is out of focus.


The G series lenses won't work in AF mode on the newer, entry-level Nikons. They require the DX series. ... Nikon D40 Digital Camera with G-II 18-55mm Lens

Digital Photo Keychain DP-151 operating sys Vista Home Premium, didn't include photoviewer software, nothing happens when connected vis USB, user manual says it should load automatic & works with my operating system. Please help!!


Hi,Check the Manual :-http://www.cobyusa.com/files/manuals/DP151_MN_151SX.pdfIt Clearly Mentioned, you need to have a CD. I am sorry, but i believe you are looking at a Wrong Manual or Some incorrect information i ... Digital Cameras

Question Hi.. I have a digital camera Sony Cybershot, DSC-P32 and I have lost my cd to download the system on my computer so I can be able to view my pictures. Please advise on where I can find the operating system cd so my camera can work. Thanks


Hi dancheIf you still want to download the software and driver for your Sony DSC-P32, you can download it from ... Sony Cybershot DSC-T200 Digital Camera

I have purcchased a new computer with Micosoft Vista operating system. My software for "Digimax S800/Kenox S800" is for Windows 98/98SE/2000/ME/XP. Is a new program available for this new system?


Driver for your camera, download HERE ... Digital Cameras

Error message: battery cover open. This message appears in the window and will not let me operate camera until problem is resolved. The cover is closed, but the message will not go away. I have re-set settings and changed memory card, but still get this message. HITACHI HDC 646E


Hi X,There's a little piece of plastic on the battery cover, that presses a switch when you slide the cover closed. Check that manually with a tooth pick and the the battery in place. Don't smash it. I have a Olympus FE -280 and it only happens ... Digital Cameras
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1121 seconds