Having problems with your Bushnell Trail Sentry 11-9200 Digital Camera ?

Will not accept current pswd or allow me to change it

\015 Does not accept pswd or let me change it.....same problem on both of my cams.\015

Answers :

Got the same problem :(
Repair Help & Product Troubleshooting for Bushnell Trail Sentry 11-9200 Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not accept current pswd or allow me to change it

Got the same problem :( ... Bushnell Trail Sentry 11-9200 Digital Camera

My DSC-T100 won't allow any changes to the flash setting.

Verify that you are not in video mode or landscape mode and try setting the flash mode then. ... Sony Cyber-shot DSC-T100 Digital Camera

Nikon COOLPIX S710 stops working after battery and/or memory card are removed. I have reformed the memory card (no change). Purchased 2X new batteries (no change). One of the original batteries will allow the camera to work, directly after a fresh charge, but not after it is removed, unless directly after insertion from being freshly charged. Have checked all 4 different batteries and voltages all appear at of above specified 3.7 VDC. Still only one of the 4 will ever allow the camera to functio

A voltage test alone cannot determine if the battery is good unless you can have the current rating of the battery tested. So if the camera comes on after a charge it seems that the battery is not retaining current for the camera to boot on.\01 ... Nikon COOLPIX S710 Digital Camera

When I change my batteries in QV-R62 I get battery is low. I open the battery compartment and reclose it an all works until I change batteries again. It sometimes that 10 open and close to get the camera to accept new batteries.

... Casio QV-R62 Digital Camera

My Nikor AF 1.8 50mm lens does not allow me to change f stops and is fixed at f22 on my Nikon N2020 AF camera. Is there some way to get this lens to allow use of all other f stop settings? Conversion ring of some kind?

You're welcome. Glad to be of service. ... Digital Cameras

I got interupted by a power glitch while I was emailing you. Don't know if I got through so will start again. My D70 Nikon will not let me shoot a picture and displays the letters CHG in the window on top of the camera. I've not seen this before and don't have my instruction book with me as I'm traveling. I changed the battery and that didn't help--battery is fully charged. I changed the card and that allowed me to take a couple of photos, then same message. Can you help me through

Your camera is broken. Either one of the CF connector pins is mashed or there's an electical failure.try to check it properly if you can or Either way, it's a job for Nikon. ... Nikon Digital Cameras

My camera has a hand in parentheses on the screen and will not allow a picture to be taken. I have changed batteries, changed out sd card but to no avail. What's the deal????

... Canon PowerShot A720 IS Digital Camera

Have the Nikon D90 camera and it does not allow me to take pictures when ever I want. It is in full auto mode and just does not want to take the picture even in bright day light. The F keeps on blinking in full auto mode and even if I switch to manual mode it does not allow me to change settings. It is very frustrating! what is wrong with this D90??

The blinking F-- means that the camera doesn't think a lens is attached. You can try removing the lens and re-attaching it. Or if you have another lens, try that. There are quite a few reports of this issue with the 18-135 kit lens. ... Nikon D90 Digital Camera with 18-200mm lens

I have a Sony cybershot DSC-W200 12.1 megapixels. It has been working brilliantly, then i turned it on one day and it will not allow me to change any of its settings, even in the manual setting. In auto i can not use flash or micro settings. What has happened and how can i change it back? I have searched through all of its menues and i cant find anything that helps.

Take out the battery and let sit for 10 minutes. reinstall battery and turn back on. everything should be back to normal ... Sony Cybershot DSC-T200 Digital Camera

Is there a way to get the DC E53 camera to accept a larger SD card than the 512mb that it currently accepts?

The following link describes the maximum SD card size for your camera.http://www.mymemory.co.uk/compatible-memory/Digital_Cameras/BenQ/BenQ+DC+E53_Memory_CardsThe following is from their site:\015\012BenQ DC E53\015\012\ ... BenQ DC E53 Digital Camera

Hi I am from Mexico I can say that I am an expert in Digital Cameras, specially Canon. Currently I am repairing a EOS Digital 350D, I changed the pins, but when i tried it, it shows ''CF error''. Could you give me a tip? I know if i changed the Main PCB the problem is solved but i think that some internally in the board was damaged, maybe some one can give a tip. Thanks in advance.

... Canon Rebel XT / EOS 350D Digital Camera

I set up a paypal account and used it succesfuly but lost the password, i then changed the password as per instructions and tried to open the account ,no luck, tried changing it again several times and creating a new one but now it will not accept my credit card as it says it is already linked to an existing account, how do i find that account ???


Memory After turning on my S500 after changing the batteries the screen flashed on and off a few times with and its seem to have changed where the pictures save to on my camera. It lost all the pictures i previously had on there and is now only allowing me to take about 20 pictures. Please help!

Sounds like the camera changed the name of the recording folder. My Sony does that sometimes with video and still frame shots, its puts them in two different folders. It also may be only recording onto the internal memory. Take the memory card out an ... Samsung Digimax S500 Digital Camera

Forgets settings My optio s40 worked well until just after the warranty expired. Then it started acting up. It maintains the default settings in auto mode. It allows me to change them, but when I shut it off and power up again, it has returned to the default settings. In Pict mode, it maintains EV +1, AWB as flourescent lighting and image size as one higher than the smallest size. Again, I can change the settings, but when I shut it off and power up again, these are the settings it has. Any idea

I had the same problem. Pentax told me to format the memory inside the camera (take out the memory stick and camera will be set to camera memory). This works! (though i have to do it approx every 200pics, the problem keeps coming back!) ... Pentax Optio S40 Digital Camera

I have a Olympus X-560WP & when I turned it on, the screen appears with a P in the left corner, a red flash symbol in the right corner & it says on the bottom +1.0 1/30 F3.7. It isn't allowing me to use any of the buttons on the side or change any of the settings. I thought if I reset the camera it would fix the problem but it won't allow me to do that either. I'm on holidays at the moment & haven't seen any camera repair shops so I can't even take it there. Do you know what the problem is o

You can try to reset it by:1. Turn it off, 2. Remove battery (the big one)3. Remove the little round battery (which supply power to rom chip)4. Remove memory card.5. Leave it for 15 minutes. ... Olympus Digital Cameras

I have a kodak m1033 that suddenly doesn't do any functions once it is powered on. I have changed the battery and swapped out battery and memory card with another known good M1033. it will not zoom, allow mode change, go to menu. just get a chance to take one picture then it freezes up until it is powered off again but still won't zoom or perform any other functions.

After some really frustrating hours on Internet I managed to solve the\015\012problem myself. 1.Connect the camera to your pc and let it charge.\015\0122.Switch on the camera and let it be detected by the pc. 3.Pull the USB\015\012out while you leave ... Kodak EasyShare M1033 Digital Camera

Power Over the last few weeks I have had issues with the batteries. I found that the "Eveready" brand certainly doesnt work (I am currently in India and it is hard to find anything here!) and I just went through 3 sets of Duracells but after a short period of time it tells me to change the batteries. I just changed them with new Duracells but when I turn the camera on it wont let me get past that initial little birdy which is the start up screen. I also just noticed that my zoom lens thinger is

Get Rechargable batteries with charger of good company and try it. Your problem is discharged/ outdated batteries. ... Canon PowerShot A510 Digital Camera

I have a Olympus X-42 camera and currently use Olympus Master 2 to upload my photos. Half of my photos uploaded and now none of the rest will. It says ''Image failed to upload'' each time. It has also said ''device not ready'' many times. After I tried to open the photos via the disk drive d and it allowed me to I attempted to manually copy and paste the pictures into my documents. It would not allow me to do so, stating that the parametres are incorrect.After this happens when I check my : D di

Why not use a separate card reader and avoid all the problems? ... Digital Cameras

Megxon c480 I have a megxon c480 and the optical zoom is stuck out. You can hear it trying to retract but the caption that comes out is that it has failed. You can not see anything through the lense either. Accept when you change the mode to setting and you can veiw setting option. What is this going to cost me to fix?

I hit mine with a hammer It works well again now. ... Digital Cameras

Help I have the olympus c-3000. I never had a manuel, therefore I have done something wrong. When attempting to take pics the "cardset up icon pops up, when I click on off, it's shuts down camara.Then when I click on ok, well it gives another message...Card Error. It will not allow me in the menu or anything at this point. I have even changed out cards, samething.

Here's the fix (condensed from another post):Turn the camera off. Then, put the camera in manual mode (turn the dial to A S M) and then take a picture. Card formats and all is fine.This works for some reason. Thanks to orig ... Olympus C-3000 Zoom Digital Camera

The switch on the back of the camera will not allow me to change between picture mode and viewing mode. The slide is free moving, does not let me choose which option I want. Can I take this slider off and manually pick the option I need? Or is this a send away and let someone else fix job?

The plastic switch has ether broken or the tab has it could be a easy fix by just removing the case and realigning the case but if your not comfortable removing the case then yeah it would have to go to a service center. I h ... Digital Cameras

View finder Camera will not switch to view finder mode it stays in LCD viewing even when the camera mode switch is changed, and will not switch to the menu allowing the card to format

I had the same problem, it is the switch inside that is broken which allows you to switch back and forth between viewing pictures and taking them. There isn't really a fix besides getting the switch replaced and I am having a very hard time trying to ... Konica Minolta DiMAGE Z6 Digital Camera

Nikon FM: Shutter release button will not allow me to take another photo and I'm only on frame 15 of a roll of 24. The film advance lever does not move the film, but it does open all the way to the right & shows the lights on inside (so the battery is OK). I changed the battery just in case, but that didn't solve the problem. I'm wondering if the film somehow came undone inside.

The FM is a mechanical camera, the batteries only power the metering system. Sometimes what happens is when you buy film say in 4 roll packages, they give you 3 24 exps and a 12 exp. I suggest that you rewind the roll and check this. You will only ... Nikon Digital Cameras

I have a Nikon D40 which is coming upto being two years old. Recently I have noticed that the auto-focus will not work. If I manually focus I can still take photos but when auto is engaged it will not even try to focus and therefore will not allow me to take a photo. I have not made any changes to the settings and therefore I am concerned it is a hardware fault. The lens in question is the standard lens supplied with the camera and is the only lens I have so have been unable to check t

The auto motor and most of the electronics for focusing are located inside the lens on this model and the camera communicates with the body via interface contacts. Try cleaning these first. If you do not get auto focus function back the lens will nee ... Nikon Digital Cameras

Flash I used to be able to switch the flash settings on the camera, when it's on 'auto adjustment', from on to off or automatic but now its just stuck on off and it doesn't allow me to change the settings. The only choice I have is to attempt using the 'twilight portrait' but I don't get the same effect.

My problem is similar. Takes photo fine. Views most recent photo fine. Cannot zoom. Cannot regulate flash. Cannot scroll photos. Cannot delete. Essentially, all those buttons are non-responsive. I first noticed it with the flash. Can you do t ... Sony Cyber-shot DSC-W100 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0742 seconds