Having problems with your Canon PowerShot A1100 IS Digital Camera ?

Lens won't extend, message says lens error - Canon PowerShot A1100 IS Digital Camera


Answers :

Fixing a Lens Error on a Digital Camera
\012


\012

This has to be THE most common failure mode for a digital camera. Some common error messages that might show up on the LCD's of cameras with this problem include "E18 lens error", or "lens error, restart camera". Some cameras might show nothing at all, but merely make a beeping noise as the lens goes out, then in, then the camera shuts off. Sometimes the lens won't even move.
\012

The problem is actually quite common throughout all camera brands. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended. Believe it or not, one BIG contributor to lens errors is using a camera case. Sand, gunk, case fibers, etc... accumulate at the bottom of the case. These materials love to cling to the camera by electrostatic build-up from the camera rubbing against the side of the case (especially those cases with soft fibrous intreriors). Once these materials work their way into the lens mechanism, that's all she wrote. I have many Canon's, and NEVER use a case for this very reason.
\012

A camera owner that suffers this problem may have no recourse for having the camera repaired. Many camera makers will not honor repairing this problem under warranty as they claim it is due to impact damage to the camera, or sand or debris getting into the lens gearing mechanism (neither of which is covered under warranty). The quoted repair cost is usually close to or more than what the camera is actually worth.
\012

Fortunately, about half the cameras that suffer this failure can easily be fixed by one of the following methods. None of these methods involve opening the camera, although some have potential to cause other damage to the camera if excessively done. If the camera is still under warranty, before trying any of these, please please first contact your camera's maker to see if they'll cover the repair, or to determine how much they'll charge for the repair. Who knows, you might get lucky. But if they quote you a number that's higher than the value of your camera, you may want to consider the following methods.
\012

The methods are listed in the order of risk of damaging your camera. Thus make sure you try them in the listed order. And remember, these fixes (especially #6 and 7) should only be considered for a camera that's out of warranty, who's cost of repair would be excessive, and would otherwise be considered for disposal if unrepaired:
\012

Fix #1: Remove the batteries from the camera, wait a few minutes. Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera on. If that didn't work, try pressing and holding the Function or OK button while turning the camera on.
\012

Fix #2: Remove the batteries, then remove the memory card. Then install new batteries, and turn on the camera. If you get an Error E30, it means you don't have a memory card installed, so turn it off, slip in the memory card and turn it on one last time.
\012

Fix #3: Insert the cameras Audio/Video (AV) cable, and turn the camera on. Inserting this cable ensures that the camera's LCD screen remains off during the start process. Thus extra battery power is available to the camera's lens motor during startup. This extra power can be useful in overcoming grit or sand particals that may be jamming the lens. If the AV cable doesn't fix the lens error by itself, consider keeping this cable installed while trying fixes 4, 5, and 7 as a means to provide extra help to these fixes. But note that I DON'T recommend keeping the cable installed during Fix 6 as you may damage the AV port while tapping the camera. Reinsert the cable only AFTER tapping the camera.
\012

Fix #4: Place the camera flat on its back on a table, pointed at the ceiling. Press and hold the shutter button down, and at the same time press the power-on button. The idea is that the camera will try to autofocus while the lens is extending, hopefully seating the lens barrel guide pins in their slots.
\012

Fix #5: Blow compressed air in the gaps around the lens barrels with the idea of blowing out any sand or grit that may be in there jamming the lens. Other variations include blowing with a hair dryer in "no heat" setting, or sucking the gaps with a vacuum (careful with this one).
\012

Now we're entering into the realm of potentially damaging your camera in conducting the fix. There is definitely some risk here, so take care when conducting the following two fixes.
\012

Fix #6: Repeatedly tap the padded/rubber usb cover on a hard surface with the intent of dislodging any particles that may be jamming the lens. Other variations include hitting a side of the camera against the palm of your hand. A lot of people have reported success with this method. HOWEVER, there is also some potential for damaging or dislodging internal components with this method, such as unseating ribbon cables, or cracking LCD screens.
\012

Fix #7: Try forcing the lens. More people have reported success with this method than with any of the other methods. HOWEVER, there's obviously some potential for damaging your camera by using this method. Variations include gently pulling, rotating, and/or twisting the lens barrel while hitting the power button. Attempt to gently straighten or align the barrel if it's crooked or twisted. Another variation includes looking for uneven gaps around the lens barrel, and then pushing on the side of the lens barrel that has the largest gap (note pushing the lens barrel all the way in is NOT recommended as it may become stuck there). While doing any of the above, listen for a click that indicates that the lens barrel guide pins may have reseated in their guide slots. If you hear this click, immediately stop and try the camera.

Repair Help & Product Troubleshooting for Canon PowerShot A1100 IS Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lens won't extend, message says lens error - Canon PowerShot A1100 IS Digital Camera


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Canon PowerShot A1100 IS Digital Camera

Lens error my camera model is canon powershot SD770 is digital elph i dropped my camera and a message is displayed as lens error i tried to restart my camera and again the message is displayed as lens error please give me a solution sir please


I've had similar problems with various versions of this camera. Here's \015\012the fix, if all else fails. These are step-by-step instructions to take \015\012apart and fix the camera's lens error. \015\012http://johnsmouth.wordpress.com/2010/12/01/l ... Canon PowerShot SD770 IS / IXUS 85 Digital Camera

I have only had my Canon PowerShot SD1400 IS Digital camera since December and all of a sudden whenever I try to turn it on, the lens does not open or move out and I receive an error message saying "Lens Error, Will shut down automatically, Restart camera." I have never dropped this camera and am concerned that it is not fixable. Please help!


It always comes because there is something loose inside the lens, such as a screw.\015\012These articles maybe helpful for you: ... Canon PowerShot SD1400 IS IXUS 130 Digital Camera

My daughters Canon PowerShot SD750 has the lens extended and stuck, turning on the camera gives a lens error message and atates to restart camera. have tried this numerous times and no help. Camera was never dropped, was just using one day, took some pictures, then the following picture I was taking lens stuck open.


Hi. This is an unfortunate mechanism failure. You can try to reset the micro board by removing the batteries for 3 mins. If that reset doesn't work, the actual lens sensor will continue ... Canon PowerShot SD750 / IXUS 75 Digital Camera

Powershot A1100 IS error lens restart camera - Canon PowerShot A560 Digital Camera


Hi there,Well Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked pr ... Canon PowerShot A560 Digital Camera

Powershot A1100 IS error lens restart camera - Canon PowerShot A560 Digital Camera


\012\012try these:-\012\012\012connect it to pc and on it\012vaccum the barrel of lens\012changing mem. card and batt. for 2min.\012 ... Canon PowerShot A560 Digital Camera

Hello I have a Canon digital elph sd600 and the lens won't retract all the way and it gives me a lens error message to restart the camera but the lens is stuck halfway - it won't extend fully and it won't completely retract. Any suggestions as to what I need to do to fix this? Thanks so much I appreciate it.


See http://www.fixya.com/support/r13011856-lens_error ... Canon PowerShot SD600 Digital Camera

Lens error, restart camera message - Canon PowerShot A590 IS Digital Camera


Try PhotoTech Repair Service, in NYC. They are factory\012authorized for most repairs, and are able to do warranty service in house. You\012can ship them your unit and, they are usually faster than the manufacturer, and\012cheaper! Plus if you join t ... Canon PowerShot A590 IS Digital Camera

Powers off my canon powershot sd600 digital camera keeps powering off after about 30 seconds. I have gotten a new battery and that didn't help. On the left hand side before it shuts down it has the letter and numbers E18 on the bottom. The zoom lens is also sticking out and will not retract. There are no error messages on the camera at all. If anyone has a solution please let me know. Thanks!


E18 is a lens error message, the lens is stuck or bent, and wouldn't come out, that's why camera shuts off after it tries to do so at the start, not much you can do, but replace the whole lens assembly ... Canon PowerShot SD600 Digital Camera

My canon powershot A710is digital camera is not starting but showing a message 'lens error restart camera'. what is the solution?


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Canon PowerShot A710 IS Digital Camera

Canon PowerShot A1100 IS Digital Camera Camera error lens restart


Hi,Checkout this tip about digital camera error messagesLens Errorfix for Digital Cameraheatman101';';';;'' ... Canon PowerShot A1100 IS Digital Camera

Get Lens " Error Re-start camera message." - Canon PowerShot SX100 IS Digital Camera


Hi.This is a common problem , generally indicated as lens error. The problem is often caused by dirt or dust in the lens gearsPossible reasons are :* Faulty lens mechanism or jammed lens (camera usually turns off b ... Canon PowerShot SX100 IS Digital Camera

Lens error, lens do not open - Canon PowerShot A1100 IS Digital Camera


Try one of these two fixes, if they dont work for you follow the link below for further troubleshooting.http://camerarepair.blogspo ... Canon PowerShot A1100 IS Digital Camera

Lens error restart camera - Canon PowerShot A1100 IS Digital Camera


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\012\ ... Canon PowerShot A1100 IS Digital Camera

Have lens error restart camera what to do - Canon PowerShot A1100 IS Digital Camera


\012try these:-\012connect it to pc and on it\012vaccum the barrel of lens\012changing mem. card and batt. for 2min.\012 ... Canon PowerShot A1100 IS Digital Camera

Lens error restart camera - Canon PowerShot A1100 IS Digital Camera


Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. O ... Canon PowerShot A1100 IS Digital Camera

Getting lens error restart camera message - Canon PowerShot SX100 IS Digital Camera


\012\012try these:-\012\012\012connect it to pc and on it\012vaccum the barrel of lens\012changing mem. card and batt. for 2min. ... Canon PowerShot SX100 IS Digital Camera

Lens will not extend, gets LENS error - Canon PowerShot G5 Digital Camera


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. To start with try to blow\015\012compressed air around the lens cover so that if there is any dirt ... Canon PowerShot G5 Digital Camera

Lens Error message PowerShot SX200 IS. - Canon PowerShot SX 200 IS Digital Camera


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digital camer ... Canon PowerShot SX 200 IS Digital Camera

Lens error My daughtor droped a Canon PowerShot A570 IS on the floor an now its broken: Lens remains extended and open, at switching-on the Error "lens error, restart camera" apeares on the LCD Screen, the Lens moves a little bit, and the camera shuts off after some seconds. Any Advise how to self repair it? Regards Peter


Hello folks,\015\012\015\012I hate to be the bearer or bad tidings but you have all suffered from what is probably the number one affliction of digital cameras - the deadly child drop :-(\015\012\015\012In almost all cases the ... Canon PowerShot A570 IS Digital Camera

Lens error message - Canon PowerShot S51S Digital Camera


Try these procedures. ... Canon PowerShot S51S Digital Camera

Lens error message - Canon PowerShot SX100 IS Digital Camera


Your camera has a lens error,\015\012 this\015\012 is such a common fault th ... Canon PowerShot SX100 IS Digital Camera

E18 error message lens will not retract - Canon PowerShot SD500 / IXUS 700 Digital Camera


HelloThe problem is that the lens has become stuck in the barrel\012 after dropping it. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\ ... Canon PowerShot SD500 / IXUS 700 Digital Camera

How do I recover from the lens error message - Canon PowerShot G11 Digital Camera


Problem: dust in the gaps near lens which makes it jammed.\012Effect: the sceen shows blk color.\012Solution: just blow over it or vaccum it. ... Canon PowerShot G11 Digital Camera

Error message that lens had a problem - Canon PowerShot SD750 / IXUS 75 Digital Camera


Usually caused by impact or sand in the lens unit - the lens needs to be dismantled and investigated. ... Canon PowerShot SD750 / IXUS 75 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6623 seconds