Having problems with your Canon PowerShot A70 Digital Camera ?
When i power on the camer its focus comes out but after 2 or 3 seconds it goback automatically and appear the text i.e. E18
It may be a internal softwere error.It is better to send to a canon service center.
Repair Help & Product Troubleshooting for Canon PowerShot A70 Digital Camera
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
When i power on the camer its focus comes out but after 2 or 3 seconds it goback automatically and appear the text i.e. E18
It may be a internal softwere error.It is better to send to a canon service center. ... Canon PowerShot A70 Digital Camera
When shooting a movie, the camera automatically stops recording after 5 seconds. about 2 seconds before it stops recording, something like a meter bar appears on the right of screen, and it jumps up from 1 block to 4 blocks and stops recording. I can't record a movie for longer than 5 seconds!
Most cameras require a card that writes data fast in order to keep up with shooting movies. If your card is slow, you might consider buying a faster (albeit more expensive) one. ... Digital Cameras
Kodak Z700 Camer appears to be in a locked out mode. The lens is stuck partway out and does not retract if the camera is turned off. When turned back on The Green light comes on for approximately 5 seconds and then goes off. The viewing screen comes on for 2 to 3 seconds and goes out as well.
Hi,Tentative solution:I had the identical problem. I went as far as disassembling the camera ... not recommended.Instead of fussing with the lens cover, I pressed on the lens assembly (gently), the lens retracted and the ... Kodak EasyShare Z700 Digital Camera
Video taping stops after a few second from starting and a message appears in the middle of the screen: "Movie recording has been stopped automatically" What to do?
Sounds like your card can't keep up. If it's an SD/SDHC card, make sure it's a class 6 or better. ... Canon EOS 550D Rebel T2i Digital Camera
Power shot SD20 digital camera When the on switch is depressed a short musical tone plays and then it stops after about 5 seconds and E18 appears on the screen momentarily before the camera turns off.
E18 is the standard Canon lens error. The lens gets stuck when extending. If you did not drop it and there are no signs of damage you can check with Canon and try to get the camera repaired under warranty.If it is not covered here are a ... Digital Cameras
My camera keeps saying: A camera error was detected Will shut down automatically Restart E32 I tried to restart it but still the message continues to appear on the screen...I can only do the preview for few seconds or a minute. Please help me fix this problem. Thank you and godbless!
HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \015\012probability is that you will have ... Canon PowerShot SD1300 IS IXUS 105 Digital Camera
The lens on my canon digital camera will not close...i am unable to take apicture and do not know the reason for this...when my camera is put on the object is not clear and in few seconds the screen is blank..i dont know what to do..please help...i have the canon powershot sd550 and the problem that appears is the E18...please help
Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or ... Canon PowerShot SD500 / IXUS 700 Digital Camera
After every couple minutes while using my camera, a message appears on the screen:a camera error was detected will shut down automatically restart camera E32, and it stays on for a few seconds, and that happens every time I use it, even while taking a video???????/
Hi there:The lens may be only slightly out of range for correct focus,so it gives the E32 lens error code. Lens errors are a common problem. Dirt can get into the gears or the lens can become misaligned from being carried in pockets, purses ... Canon Digital Cameras
Error-C1 I was on holiday in dusty hot conditions when my second hand camara became unusable. I turned the camara on to take a photo and the zoom lens and shutter became stuck. The screen went blue and 'error-C1' appeared on the screen. Every time I turned it on thereafter the same blue screen came up and it makes a strange mechanical noise when I turn it on. It also turns itself off after a few seconds but the zoom still doesn't shut. The battery symbol still appeared but it appeared to be out
Dirt /dust in the lens and lens gear box ( this drives zooming only ) preventing optimum functioning. Lens cannot properly come on line ( shutter and diaphragh mechanism then do not come on line ) and the camera switches off. Solution : is ether repl ... Kyocera Finecam S4 Digital Camera
E18 appears in lower left part of screen when camera is turned on
The E18 error is fairly common on certain Canon models. Here's a link to information on what usually causes it and how to fix it. http://www.e18error.com/ ... Canon PowerShot A85 Digital Camera
E18 my canon powershot A150, got the whole E18 problem, it turns on with the blue canon screen, but then two seconds after it turns into a faded black with E18 in the bottom left hand corner. i seriously dont know whats wrong, and it hasnt even been a year since i got the camera, is there any way i can fix this problem? because at the moment buying a camera, my parents would not be too pleased :| it turns on with blue screen then it goes black and it says e18
E18 is the canon fault number for lens error. Is the lens stuck out? does it click when the camera is switched on? Try lightly tapping the lens on a hard surface. This sometimes resets the lens. If all this fails take it to bits! (but watch the flash ... Canon PowerShot A400 Digital Camera
When using the flash is takes 4/5 seconds before I can take another picture. The taken photo appears for about 1 second then the screen goes black for 4/5 seconds before I can take another picture
I don't think it's the time to write the file. The original post says "when using the flash". The flash uses a big burst of power by discharging a capacitor or multiple capacitors. They take time to recharge. 4 or 5 seconds sounds about right. As yo ... Canon Powershot A2000 IS Digital Camera
Sometimes, when I take a picture with my 40d the automatic shutter speeds that display can fluctuate dramatically from 100th of a second to 10th of second in just a split second before I press the shutter, leaving me with an overexposed picture. Why does this fluctuation happen?
Your camera is probably set to SPOT exposure instead of AVERAGE exposure,. Which means, your camera is taking readings from a smaller area within the frame instead of using the whole frame to decide exposure. When in spot exposure you can move a hai ... Canon EOS 40D Digital Camera
I never had a problem transfering my pictures from the camera onto my computer. I plug in a USB cable on my Dell laptop and into the camera, after a few seconds a dialog box appears that says: "import pictures" and that is what i click on. The dialog box no longer appears. Please help.
Hello. With your computer turned on try plugging in the cables with the camera turned off. After the connections are made turn the camera on. This usually works for my Kodaks. If that don't work right click" My Computer" and see if your camera shows ... Kodak EasyShare CX7525 Digital Camera
I have a canon powershot s5o, and the other day i turned it on,was going to take a photo and appeared E18. it turned off but the lense of the camera did not go inside the hole and cannot close it.. i try to turn it on and appears the first image,and immediately whites stripes on the blackground. and try again and the same. the lense is stuck there i cannot close the thing that covers the lense
... Canon PowerShot S50 Digital Camera
My Olympus C-770 camera will not record movies beyond a few seconds. It seems like anything over 30 or 45 seconds just gets corrupted. When I try to watch a corrupted movie on the camera, it displays "Picture Error" on a blue background with red text, and a red exclamation point in a red rectangle. They won't play on my computer either.
... Olympus Camedia C-770 Digital Camera
When the camera is switched on aftera few second the following message appears "please turn camera off and then on again" If you do this then the message appears again and so on. Any help please
HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \015\012probability is t ... Panasonic Lumix DMC-TZ3 Digital Camera
My dimage z3 takes lovely photos, which appear on screen, only to disappear after a second with a 'system error' message. When I look at the 'viewing photos' option, a red triangle with an exclamation mark inside, appears. So my photos are on the camera, but inaccessible. I have had it fixed under warranty once for the same problem, but that has now expired. It is over 5 years old now
This could be a problem writing to the memory card. The first thing I would try is inserting a different card (SD type) as a test. ... Konica Minolta DiMAGE Z3 Digital Camera
E18 I have a SD450. When I push the on/off button it appears black with E18 in the lower left corner. I have had this camera for three years and is no longer under warranty. Thanks.
Lens errors are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or ... Canon IXUS V2 Digital Camera
I have a Panasonic DMC-TZ1 that I can't get the flash to go off on. The only flash setting that works on my camera is no flash setting and the icon for the no flash symbol appears white. The rest of the settings such as automatic flash with red-eye, and automatic flash, ect... are red. Is this a settings issues or a repair issue? If it is a repair issue could you tell me what on the camera needs to be repaired. Weather it be the LED light is broken or a resistor or transistor on the circuit
... Digital Cameras
My DMC_FX500 When in a record mode after about 10 seconds the LCD comes up withe the message ... "Please Turn Camera Off and then On Again". The lens retracts and then extends again but this message reappears whenever the camera is turned off and then on again. Can still view previous pictures I Can take pictures within that 10 seconds Only. Any ideas what might be causing this message to appear? I Have "dampened" a cotton earbud with Isoproply alcohol and cleaned inside the battery comp
HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that ... Panasonic Lumix DMC-FX500 Digital Camera
E18 turn on camera whirring noise shutter does not open after a bit the e18 appears in the screen. then shuts off.
The E18 error is fairly common. Here's some things that you can do to try to correct it. Have already fixed several cameras with this problem by using these methods:\015\012\015\012 ... Canon PowerShot A75 Digital Camera
My new Canon G11, purchased in August,2010: 1) The camera cord (to load photos from camera to computer) is no longer interfacing, but the card works (I don't think it is the software as it malunctions on both office PC and home Macpro). Also noticed that sometimes when trying the cord, when I turn camere on, the lens comes out, which never happend when transferring photos via cord 2) I noticed shortly thereafter that the camer no longer "beeps" when the green in-focus boxes appear on hte view
It sounds to me like one or more of the wires in the cord has broken, or there is a problem with the USB port on the computer. Try swapping to the other ports to see if the problem goes away before going forward.If the problem is present ... Canon PowerShot G11 Digital Camera
Olympus C-4000 doesn't complete the power up cycle. It goes fine until the number of pictures taken appears on the bottom left for one second. At that point the screen is black and then everthing goes black. The motor whirs for a couple of seconds and the lense barrel stays out. No buttons have any effect. I've put in fresh batteries.
You will need to send the camera in for repair, check your warranty if you have warranty contact your dealer or camera maker.\015\012\015\012if you are outside of warranty you can get a free repair estimate from\015\012 ... Digital Cameras
White Screen Upon startup lens emerges but when screen appears it is white whereas it normally displays whatever the lens sees. When the shutter button is pressed the camera will focus and take a white picture which can be deleted. The camera does not flash although flash is set to automatic and photo taken in a dark room. Camera flashes (weakly) with flash set to manual on. Lens is unobstructed and appears to be perfectly normal. Camera was not dropped. Batteries have been changed.
\015\012Upon startup lens emerges but when screen appears it is white whereas it normally displays whatever the lens sees. When the shutter button is pressed the camera will focus and take a white pictur ... Pentax Optio E10 Digital Camera