Having problems with your Casio Exilim Zoom EX-Z80 Digital Camera ?

Reads card error or turns off once i insert memory card

\015 My casio exilim 8.1 camera reads card error and turns off when i insert memory card\015

Answers :

Hello

OK, if the memory card itself is locked, you might \012sometimes get this error code. All you need to do is to take out the \012memory card and switch the lever on the left side to the unlock.

6c99e31.jpg

If\012 the error is still displayed after you did the above, you might want to\012 try the card in another camera.

If\012 the card works in another camera . the problem is with your card reader\012 in your camera.

If you open you sd slot and look inside with a \012sharp light , you should be able to see on the left side of the slot \012there is a little copper or spring steel lever switch. This switch work \012as follows:

1. When no card is inserted / no write protection ,\012 the switch is open and thus the protection is off.
2. When locked\012 card is inserted , the tab is depressed and tells the camera that the \012card is lock.

Contrary to popular belief ,the little tab on the \012sd card is not an electronic switch and does not physically influence \012the card operation itself. If you put a locked card into a camera \012without a sd lock switch , you would still be able to use the card \012normally.

It is incredible difficult to fix this switch because \012of space limitations in the sd card. Look into the sd slot and if you \012can see the switch , use a needle to pull the little tab down toward the\012 base of the camera by about 2mm or until it works being careful not to \012bend it.

If this does not resolve your problem , there might be a\012 short in the switch circuit and the camera will need to be disassembled\012 to resolve this error. This should cost no more than $50.

Please\012 feel free to contact me if you need further information

Kind \012regards
Andrea
Repair Help & Product Troubleshooting for Casio Exilim Zoom EX-Z80 Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Memory card errors. I turn it on and get message MEMORY CARD ERROR PLEASE CHECK CARD. Occurs on different cards. Sometimes I can clean the contacts on the card and it will work. Sometimes, I can take pictures but if I remove the card it cannot be read if install it back or by a computer or printer. I use the camera as publicity in trade shows taking then printing pictures, so the cards are removed and inserted constantly. I have reformatted the card in the camera, still fails.


Hi wait a moment pls your request is been proceeding.. ... Panasonic Lumix DMC-FZ18 Digital Camera

Memory Card Hello, I'm not sure why my camera powers on when the memory card is not in but when I insert the memory card and try to turn it on, it doesnt power up and then when it does, the little green light blinks and then it reads memory card error. Please Help!1


Look to see if your memory card (your SD card) is "locked".for some reason, when a "locked" card is in my canon SD1000, it won't turn on at all.but when i unlock the card and put it back it, it works fine. ... Canon PowerShot SD630 Digital ELPH / IXUS 65 Digital Camera

Reads card error or turns off once i insert memory card


HelloOK, if the memory card itself is locked, you might \012sometimes get this error code. All you need to do is to take out the \012memory card and switch the lever on the left side to the unlock. ... Casio Exilim Zoom EX-Z80 Digital Camera

Hi.....i am havimng a problem with my memory card PNY Optima SDHC 8 gb class 4......i have been using it in my sony camera....its was working fine at the start but recently after when i inserted the memory card in my camera it say "system error" or "error formating memory card".....i tried other memory cards in my camera and it worked..so i thought to formating my card using my camera usb cable but when i inserted the cable to my pc it says your disk is in read only format and make sure its ch


You will most likely find that your camera will work with cards up to a certain capacity e.g. 2gband not with cards of higher capacity. What this means in effect is that high capacity cards are not compatible with your camera. It would be inter ... Digital Cameras

Bought a memory card for my Kodak 'EasyShare' C530 and I don't know if it's the right one. I bought a 2GB Memory card with MMAGFQ2WDCA-D8 on the back of the card itself. The error message I get is 'error' 'Memory card cannot be read'. Please insert another card' Error : e00100' Can you help me ?


There are regular SD cards and high-capacity SD cards (HCSD). Some\015\012devices are not compatible with HCSD cards. It sounds like your camera\015\012is not compatible. You may still be able to purchase 2G & 4G\015\012regular format SD cards t ... Kodak EasyShare C315 Digital Camera

Cannot format new memory card reads: systen file error. I have bought 3 new memory cards for my kodak easyshare 315. each time i insert the new card i get a message that reads system file error. camera has not been dropped or come in contact with water


Go into the menu and find "reset"...follow the on-screen instructions. ... Kodak EasyShare C315 Digital Camera

My camera doesn't recognize that the memory card is inserted (error message "no memory card!" displays), and when i tried a different card it read "memory card error". whats going on?!


... Canon PowerShot SD630 Digital ELPH / IXUS 65 Digital Camera

Canon ZR200 memory card say ''card error'' when inserted. Card is not locked. I have formatted it. Have used 3 different sizes of cards. Sometimes it will say ''card error'' then start working a couple of days later as if nothing was wrong. Last card used worked for 13 pics then started ''card error'' next time I turned it on. Currently it just says ''card error'' all the time.


Sounds like the contacts for the cards are dirty. Turn off the camera and remove the batteries before doing the following.\015\012\015\012Try taking a piece of card stock (or a manilla folder) and cut it to the size (width only) of your ... Digital Cameras

I have a Kodak EasyShare v1003 and when i turn it on it says Reading memory card!! then it says Memory card needs Formatting.. when i format it it then says Memory card is unusable insert new memory card... so far i tried 3 different cards and no luck.. all the cards work on my other camera's but not this one>> Help Thanks


Format ur card in different cam ... Fuji FinePix A500 Digital Camera

I insert the memory card correctly and then when I turn it on and it says memory card error and wants me to insert a card. My camera is a Power Shot SX30 IS


First question -- did you already format the card? If yes, then follow this: Occasionally, but not often, the memory cards will become "zapped," and they will not function. Have you tried reading from the same card on another device? (e.g. computer). ... Digital Cameras

Loaded new memory card, and screen reads memory card error-memory card locked. Removed new card from camera, nnlocked card, inserted card again, but received same message. Please advise.


I'm guessing you bought a new 4GB SDHC card. Although it looks exactly the same as a standard SD card, the format the card uses is very different. If your camera is more than a few couple years old, it's likely it was designed before the SDHC format ... Canon Digital Cameras

My camera won't let me take any pictures or look at them. Everytime I turn it on it says memory card error, card locked. i've tried moving the locked switch on the side of the card up and down but that hasn't done anything. and i know it isnt my camera because i put an old memory card in it and it read that memory card just fine. I have pictures on there that i dont want to lose and i tried putting them on my computer but it says i didnt take any pictures..I know i did though because i used it t


It sounds like your media is malfunctioning (controller issue).Our company, LC Technology, is the only Sandisk-appro ... Fuji FinePix A350 Digital Camera

My Lumix DMC FZ30 use to work using a 4gb SDHC SanDisk card, but now says, "Memory card error please check the card". However, the card works fine in any other cameras. A small pocket Fujifilm camera for example. I was told to reformat the card in the camera, but I'm unable to use any part of the FZ30 camera while the card is inserted and on. Please help as I want to use my 4gb card and not just the 2gb ones which work fine so I know it's not a problem with the camera reading memory cards, just


Memory cards have a limited life. If you've been using it a lot and erasing it or formatting it, it probably is just worn out. Take it to a camera shop and try a new card. If that works, go to a discount store and buy a new one. It will cost less ... Panasonic Lumix DMC-FZ30 Digital Camera

READ ERROR When I look back at the photos I have taken with the Finepix A360 there are a few that say "READ ERROR" and do not display the photo. Now when I connect the camera to the computer, only 1 of the 280 photos will open up, the rest of them do not display. The memory card is xD M 256 MB. What can I do to retreive my photos!? when I turn on the camera to view photos it says read error


The photo was not recognize when you took itthats way it would say read error. no way to retrieve thos pics...sorry.. ... Fuji FinePix A400 Digital Camera

My camera wont read memory cards anymore. It was working just fine, then the next picture I tried taking it said "memory card error" and the memory card works in other cameras, and my camera turns on and I can navigate thru it. What could be wrong?


HelloOK, if the memory card itself is locked, you might \012sometimes get this error code. All you need to do is to take out the \012memory card and switch the lever on the left side to the unlock. ... Canon PowerShot A610 Digital Camera

Hi, I have a Canon Power Shot S2 IS 5.0 megapixels that was working fine until one day I changed the memory card from 512MB to a 1GB. Now every time I turn the camera on and try to take a picture, a beeping sound and a legend on the LCD screen that reads: Memory card error. It's like something locked the shutter mechanism. I tried other memory cards with the same results. Thanks, Roger.


Its possible that there may be an error on the camera try to reset the camera by \015\012\015\0121. Turn the mode lever to the camera or play button\015\0122. Press and hold the MENU button for more than 5 seconds.\015\0123, T ... Canon Digital Cameras

CAMERA READS -CARD ERROR-AFTER INSERTING A NEW MEMORY CARD


First, make sure that the new memory card does not have the protect tab in the lock position. The new card must be unlocked and formatted before your camera will be able to use it. Also, make sure that the size card that you have purchased has not ... Vivitar ViviCam 5386 Digital Camera

Card problem 2 days ago i got the memory card out of the camera and insert it into my notebooks card reader, after i insert it back into the camera and error message appeared "card not initialised" and i can't figure out what the problem could be tho the laptop has no problem in reading the card. can i have some help pls ?


After downloading to the computer, did you use the computer to erase the card? If so, you need to format the card in the camera. ... Fuji FinePix S5700 Digital Camera

I have an Olympus C-740 Ultra Zoom Digital Camera. I bought a new memory Card. This camera is new to me and this is the first memory card I have purchased. I do not have a manual for the camera. I am having a problem getting the camera to read the card. I insert the card, turn on camera & the window says "no picture". I changed the batteries also. I can get a oval ring which says "Info on the left, picture of cards at the top, "Mode Menu" on right, & bars at the bottom.It appears the "Mode Menu"


Choose YES for the Format option. Allow it to finish. Should work fine then.\015\012Possible defective card if does not work after full format. Do not use any "quick format" option.\015\012First time must be FULL format. ... Digital Cameras

I removed the memory card from my computer and re-inserted into my Canon Elf 800. when I turned the camera on the message "Memory Card Error" appeared on the screen with the tag line "Card Locked". I tried sliding the the small slide on the side of the chip, but nothing changed. The card looks like a Micro S C.


When you removed the card from the computer, did you remember to use the "safely remove hardware" function? If not, this could be the problem. The solution is to download the pics to your computer to save them, and then format the card in the camera ... Digital Cameras

Brand new Panasonic LumixDMC-TS1. When the camera is turned on, message reads "Memory card error Please check the card". We cannot get past this unless we remove the card and simply use the built in memory. Bad card or problem with the camera?


Have you tried formatting the card - either in the camera, or on a computer? ... Digital Cameras

I have damaged my xd memory card by inserting it into the wrong memory card reader. i did managed to get it back out but i have damaged it. i can see scratches on the gold contacts. my camera is now saying it can't read the card as it has an error, nor will it let me format the card....Help...please


As the card is damaged you cant do anything just replace with another card ... Digital Cameras

My olympus 8010 will not accept my memory card. Whenever it turns on it says it want to format the card and when I try to format it it says card error. Internal memory works fine. I can't do anything when the internal card is inserted.


Remove your card and place it in the carrd reader of your PC. Now try to format and clean off the files. If it is not detected clean contacts and try if not the card can be defective. ... Olympus Digital Cameras

Card error When I turn on my camera it says card error and will not allow me to take any photos. I have put in another memory card and it still reads the same. How can I fix this problem ?


For the image file numbering problem: Go into the setup menu and set the numbering option to "renew" instead of continuous. For the card error: use the setup menu and format the card in the camera. This will erase everything on the card, so you will ... Fuji FinePix E500 Digital Camera

When I turn my camera on it reads "pictures will be recorded to built in memory". I have an SD ultra II 4.GB memory card inserted which I know isn't full. How do I get my camera to save to memory card? Regards Michelle B


A card that size is actually an SDHC card. SD and SDHC cards fit the same slots, but they are slightly different. Many cameras won't work with the SDHC (high capacity) cards. SDHC is not backwards compatible.I expect your camera just won' ... Panasonic Lumix DMC-TZ3 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3328 seconds