Having problems with your Fuji FinePix J10 Digital Camera ?
How do I activate the flash? It reads deactivated. Appreciate your feed back. Thanks Tom
There should be a button with a lightning bolt on or by it. Press that button and watch the screen.
Repair Help & Product Troubleshooting for Fuji FinePix J10 Digital Camera
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
How do I activate the flash? It reads deactivated. Appreciate your feed back. Thanks Tom
There should be a button with a lightning bolt on or by it. Press that button and watch the screen. ... Fuji FinePix J10 Digital Camera
Error 5 ! Canon Rebel Xti w/ 28-135mm It was working fine! had it for 10 day's and after about 560 images taken ( 4 gig flash card ) The message read : "The built in flash auto pop up was obstracted... turn it off and on again..same problem. any simple tip ? solution ? or take it back to the dealer. I appreciate your Help ! Peter Toronto
\015\012Try the scotch tape or masking tape technique: get around two to three inches long sticky tape, stick about an inch above the flash housing, turn on the camera, hold the remaining tape upward , shoot the came ... Digital Cameras
I HAVE A NIKON SB-800 FLASH UNIT AND I WAS TAKING PHOTOS OF RACECARS AND SOMEONE ELSE THERE HAD FLASH UNITS SET UP ON BOTH SIDES OF THE RACE TRACK WITH REMOTES, AND NOW MY FLASH WONT LIGHT UP AND THE SCREEN READS MRPT A RPT AND UNDER THAT IS BRPT CRPT AND OVER TO THE RIGHT SIDE IT READS CH4 STBY 80 AND BELOW IS F11 XM ZOOM 14MM WHAT DO I NEED TO DO TO CANCEL THIS SETTING AND GET BACK TO MY REGULAR SETTING AND HAVE
Hey ljthomp6_30,\015\012 I would just reset the flash back to the manufacturers default setting, which is done by pressing the mode button and the on/off button simultaneously for about 2 seconds. Keep in mind this wi ... Digital Cameras
My nikon d60 wont take picture when the flash is activated. the flash wont fire too but would pop up. if flash is deactivated, i could take pictures with it.
... Nikon D60 Digital Camera
We just purchased a Nikon Coolpix L110 digital camera. We completed the start up process and attempted to take a few test photos. we took two photos with flash and on the second photos, a loud noise was heard when the flash operated. We could never get the flash to operate again. We have read through the troubleshooting guide supplied with the camera and changed batteries and settings. No luck. Any assistance would be appreciated!
Your flash shorted out...manufacturing defect....return the camera. ... Nikon Digital Cameras
Intermittent problem The camera works fine for awhile then the 4-way selector suddenly will not change the menu. Or it gets stuck on full flash or no flash. The selections may get mixed up. The review won't activate except for the last shot sometimes. Then if you leave the camera for a couple of days it seems to fix itself. Everything is fine then suddenly all the troubles come back. Although it gets messed up like this you can still take photos with it and you can use the other modes usually to
Sometimes, by changing the swithces of the control panel solves the problem ... Sony Cyber-Shot DSC-S85 Digital Camera
I have a panosonic TZ3 and i can not upload the JPG or video image files to my imac. I have followed all instructions and even when the computer is turned off camera will not mount or activate an untitled folder to the desk top when using the usb connection and turning the computer back on. the mode dial on the camera is set to play back but nothing happens. Would appreciate any advice!
Use a card reader to download your pictures to a folder you create on your desktop. ... Panasonic Lumix DMC-TZ3 Digital Camera
Broken lcd could someone tell me the order of the menus and sub-menus? ive tried looking for pictures of the menus but i cant find them anywhere not even in the manual. somehow, my camera stopped automatically reading the card and i cant change it back because i cant see the menus. any help would be appreciated.
... Kodak EasyShare C643 Digital Camera
I can not get my camera to take clear pictures. They look blurry and the flash sometimes not make the picture as light as it should. I have spent many hours playing the the camera and reading the manuel just to become more frustrated. Is there a way to take the camera back to manufacture default and start over.
To reset the camera, put camera in camera mode, press menu and the reset should be on the left.\015\012\015\012Also if you have the image stabilizer on, turn it off.\015\012\015\012The last thing is the most digital cameras do ... Olympus Digital Cameras
PLZ HELP!!! I HAVE A SONY DSC T-20....bought it a couple of weeks back..i have a problm....it was working fine when all of a sudden when i try to switch it on..it dusnt turn on even when the batterys fully charged..i noticed smthing..when i insert the battery the red light flashes for a sec n then goes away!!!! ne help wud be highly appreciated!!! thnx ankit [email protected]
Its finally fixed now..took it to the service center..they replaced the connector....its been a couple of months now..and thankgod.no problems till now!! ... Sony Cyber-shot DSC-T20 Digital Camera
Hi i have a compact flash 4gb memory card and there were approx 2000 photos on there. i shut the camera off, put it back on ten mins later to a message saying no cff card.. and it now wont work or be recognised on any card reading system.. i obviously dont want to lose all those images is there anything i can do thanks!!!!!
The camera probably has a removable memory card. often it is located in the same place as the batteries. Remove the memory card and use an external card reader. (they can be obtained from any camera store or from Walmart. The reader should have a ... Olympus Camedia C-4000 Zoom Digital Camera
I have a Canon sd630.The camera works great except that it won't remember its settings. Upon turning on the camera,it would say it's in manual mode, but if I change it to automatic and then turn it off. It would be back in manual mode again. I have reset the camera and even taken apart to replaced the internal battery. Still no luck. Appreciate any help. f.y.i I have tried looking for a firmware update, but no luck either. I was wondering if I could flash my camera with the sd500 firmware? I ju
Try to follow the route up the circuit from the battery on the motherboard.\015\012maybe the battery is ok but the power not rich to the mother board or memory chip.\015\012take more attention on the connectors. ... Canon PowerShot SD630 Digital ELPH / IXUS 65 Digital Camera
Hi, I have a Canon 20D and a Sppedlite 550EX (I use for almost every shot). My problem is that 80-90% of my photos always return back from the printers too dark. I know this sounds like a printing issue, however I have tried 4 different printers and still have the same problem. I have tried up'ing my exposure both on my camera and flash, but this just overexposes parts of the photo too much. My histogram also looks relatively correct on these shots. I appreciate that photos will be taken too dar
Your exposure maybe off. Unless you are trying to suggest that the LCD displays pictures taken with a flash differently than those taken without one!On an LCD, underexposed picture will still look "ok" but, the Histogram tells the tale. I ... Digital Cameras
Canon Power shot SD950 IS Digital ELPH camera lents will not extend on back screen it reads lens error restart camera camera was in use the previous night testing a flash unit and was not knocked etc thanks for your help jk mc darby
See http://www.fixya.com/support/r13011856-lens_error ... Canon Digital Cameras
I have a new (3 weeks) D700 and while taking photos yesterday with camera and a 16-35mm lens, the exposure meter went ape. Pictures taken ok but ERR started to flash where shutter speed reading should be displayed in viewfinder. Tried everything, including resetting to factory settings, detaching and reattaching lens, checking switches, and then went home in despair. At home I switched to a 50mm lens and the problem disappeared. I put the 16-35mm lens back and problem seemed to have disappeared.
... Nikon Digital Cameras
Same Problem When I hit the power button, it flashes, the HP logo comes up on the screen the lense retracts and comes back out and the power goes off. That's all it will do. Other times when I turn it on, a little yellow light on the bottom left side in the back flashes once after the blue power light flashes three times and then turns back off. Arggggghhh!
Use never used batries i have the camra it work s better with new batries ... HP Photosmart M525 Digital Camera
We insert a memory chip into our Kodak EasyShare C190 camera. The read-out informs us that the memory card requires formatting. We click on "OK." The camera goes into a "formatting" mode, then informs us that the memory card cannot be read. It goes back to the "Memory card requires formatting" prompt, we click on "OK," it goes back into the "formatting" mode, then tells us again that the memory card cannot be read. We can't do anything else with the camera until we take the chip out, then we hav
Your camera is only supporting SD/MMC Cards (up to 2 GB) and KODAK SDHC Cards (up to 8 GB). \015\012The card that you currently have might be faulty. Please try another card.You might also need to switch the camera over to saving pictures ... Kodak Easyshare C190 12MP Digital Camera with 5x Optical Zoom and 2.7-inch LCD
AF problem Last week I took some pics that needed the flash turned off. I did that and took the pics with no problem. I turned the flash setting back to "auto" afterwards. (this may not be related to the current problem but does seem too much of a coincidence). Next time I went to use the camera, I got an AF(red dot) and a red hand on the screen. It would take one picture and then would be frozen (no zoom, no picture taking, but the screen would stay on). If I turn it back on I can then ta
Jangles,\015\012\015\012I am having the exact same problem. Have you found a fix ? ... Nikon Coolpix 5600 Digital Camera
I took my CF card out to get photos, went to put it back in and the screen read "There is a problem with CF card. Replace the CF card." I didn't think there was a problem with the card. But I replaced it anyway. Same message. I tried to format the new card and a message read err 99 turn it off and on and reinstall battery & put it back. I did all of that. Same message about the CF card.
Your CF pins in the camera are most likely bent/broken. This is a very common problem. Most repair shops will charge $150-$200 to repair this.\015\012\015\012Hope this helps.\015\012\015\012Wes ... Canon Rebel XT / EOS 350D Digital Camera
My camera worked before by uploading pics onto the comp. Now it doesn't let me at all. I tried to upload tonight and first noticed the problem. So I restarted and got back on tried it again it worked but only half of the way then it said unable to read device (I already tried to troubleshoot the device in my comp nothing came back wrong). I then restarted again and this time it didn't even try to bring up the pics it just came up with a screen that said Unable to read device. I deleted the softw
Consider NOT connecting your camera to your computer.\012\012\012The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to ... Kodak EasyShare V1073 Digital Camera
Hi, I've just recieved my nikon d90 back from a repair and service, and although everything appears to be working fine, whenever I want to change shooting modes,( auto, P, M, flash off etc), they only work once I have selected them, and then turned the camera off and back on. In other words I cannot be shooting in the Auto mode and then switch to "flash off auto"....all that happens is that the auto focus works but the shutter will not operate. If I switch the camera off and on however, I can t
I'm going to assume at this point that the camera has been serviced correctly. What I'd suggest is that you look in your manual and find where you can reset your camera back to the factory default settings. Okay here are a few thoughts that might be ... Nikon D90 Digital Camera with 18-105mm lens
Used Vivitar 70-200 zoom on my K200 Pentax. Nothing but aggravation since. Right now the 18-55 lens it came with is on but shutter button is stuck in down position and my flash wont pop up using the manual "up" button. When I look thru lens and push button, flashing "F" is the only thing there. Removed lens and button would move enough to "click" but would not come up. Put lens back on and nothing! Newbie in the extreme and ready to go back to my MX !!
The issue here is the manual mechinsm is in defect, Your going ot hate me but there is not much I can do over email but to tell you a local camera shop can take care fo this for cheap. Whats going on is the mechism is jammed most of these are spring ... Pentax K200D Digital Camera with 18-55mm lens
Missing pictures I recently went on a trip and took some pictures that disappeared from my camera. Later I started getting the message 'Card cannot be read' so I purchased another memory card. I was taking pictures when I get the message 'Card cannot be read'. I turned it off and back on and the missing pictures were there. I then get the message 'Out of memory'. I turn the camera off and back on and the missing pictures are gone again. WHERE ARE THEY???
Hey flowernthe,\015\012 The error message “card cannot be read" means there was and error when the camera tried to access the memory card. To fix this you should make sure you are using the right kind of memory ... Nikon Coolpix 4600 Digital Camera
I cannot turn the flash back on. When I push on the lightning bolt button nothing happens, the display shows the flash turned off. Is something wrong with the camera. I have not had it that long and just use the IA mode and I know it worked before; can I reset the camera back to factory settings? I tried all the other modes and was able to use in in C1 but then I was messing around with that and now won't work in that either. Thank you for your help.
... Panasonic Lumix DMC-FZ28 Digital Camera
I have Sony DSC T2. I am facing some problem with flash. It only shows a single icon for flash (flash off). no other option appear when i touch on flash icon. it also blinks with E:93:1 at the middle of the screen and flash icon at the bottom when I open lens door. During this I don?t find any flash option (auto and timer). Would really appreciate if you could help me here.
Hi i had the same problem \012just go to HOME option \012then MAIN SETTING\012then click on the initialize option \012and reset the factory setting \012it resolve my problem \012hope it will solve your problem tooo ... Sony Cyber-shot DSC-T2 Digital Camera