Having problems with your Konica Revio KD-310Z Digital Camera ?

Konica digital revio kd 310z was dropped and shows error s0042

\015 Konica digital revio kd 310z was dropped and now the lense is partially closed and will not do anything and shows an error message s0042\015

Answers :

Fixing a Lens Error on a Digital Camera
\012
\012This has to be THE most common failure mode for a digital camera. Some common error messages that might show up on the LCD's of cameras with this problem include “E18 lens error”, or “lens error, restart camera”. Some cameras might show nothing at all, but merely make a beeping noise as the lens goes out, then in, then the camera shuts off. Sometimes the lens won't even move.
\012The problem is actually quite common throughout all camera brands. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended. Believe it or not, one BIG contributor to lens errors is using a camera case. Sand, gunk, case fibers, etc... accumulate at the bottom of the case. These materials love to cling to the camera by electrostatic build-up from the camera rubbing against the side of the case (especially those cases with soft fibrous intreriors). Once these materials work their way into the lens mechanism, that's all she wrote. I have many Canon's, and NEVER use a case for this very reason.
\012A camera owner that suffers this problem may have no recourse for having the camera repaired. Many camera makers will not honor repairing this problem under warranty as they claim it is due to impact damage to the camera, or sand or debris getting into the lens gearing mechanism (neither of which is covered under warranty). The quoted repair cost is usually close to or more than what the camera is actually worth.
\012Fortunately, about half the cameras that suffer this failure can easily be fixed by one of the following methods. None of these methods involve opening the camera, although some have potential to cause other damage to the camera if excessively done. If the camera is still under warranty, before trying any of these, please please first contact your camera's maker to see if they'll cover the repair, or to determine how much they'll charge for the repair. Who knows, you might get lucky. But if they quote you a number that's higher than the value of your camera, you may want to consider the following methods.
\012The methods are listed in the order of risk of damaging your camera. Thus make sure you try them in the listed order. And remember, these fixes (especially #6 and 7) should only be considered for a camera that's out of warranty, who's cost of repair would be excessive, and would otherwise be considered for disposal if unrepaired:
\012Fix #1: Remove the batteries from the camera, wait a few minutes. Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera on. If that didn't work, try pressing and holding the Function or OK button while turning the camera on.
\012Fix #2: Remove the batteries, then remove the memory card. Then install new batteries, and turn on the camera. If you get an Error E30, it means you don't have a memory card installed, so turn it off, slip in the memory card and turn it on one last time.
\012Fix #3: Insert the cameras Audio/Video (AV) cable, and turn the camera on. Inserting this cable ensures that the camera's LCD screen remains off during the start process. Thus extra battery power is available to the camera's lens motor during startup. This extra power can be useful in overcoming grit or sand particals that may be jamming the lens. If the AV cable doesn't fix the lens error by itself, consider keeping this cable installed while trying fixes 4, 5, and 7 as a means to provide extra help to these fixes. But note that I DON'T recommend keeping the cable installed during Fix 6 as you may damage the AV port while tapping the camera. Reinsert the cable only AFTER tapping the camera.
\012Fix #4: Place the camera flat on its back on a table, pointed at the ceiling. Press and hold the shutter button down, and at the same time press the power-on button. The idea is that the camera will try to autofocus while the lens is extending, hopefully seating the lens barrel guide pins in their slots.
\012Fix #5: Blow compressed air in the gaps around the lens barrels with the idea of blowing out any sand or grit that may be in there jamming the lens. Other variations include blowing with a hair dryer in “no heat” setting, or sucking the gaps with a vacuum (careful with this one).
\012Now we're entering into the realm of potentially damaging your camera in conducting the fix. There is definitely some risk here, so take care when conducting the following two fixes.
\012Fix #6: Repeatedly tap the padded/rubber usb cover on a hard surface with the intent of dislodging any particles that may be jamming the lens. Other variations include hitting a side of the camera against the palm of your hand. A lot of people have reported success with this method. HOWEVER, there is also some potential for damaging or dislodging internal components with this method, such as unseating ribbon cables, or cracking LCD screens.
\012Fix #7: Try forcing the lens. More people have reported success with this method than with any of the other methods. HOWEVER, there's obviously some potential for damaging your camera by using this method. Variations include gently pulling, rotating, and/or twisting the lens barrel while hitting the power button. Attempt to gently straighten or align the barrel if it's crooked or twisted. Another variation includes looking for uneven gaps around the lens barrel, and then pushing on the side of the lens barrel that has the largest gap (note pushing the lens barrel all the way in is NOT recommended as it may become stuck there). While doing any of the above, listen for a click that indicates that the lens barrel guide pins may have reseated in their guide slots. If you hear this click, immediately stop and try the camera.
Repair Help & Product Troubleshooting for Konica Revio KD-310Z Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Konica digital revio kd 310z was dropped and shows error s0042


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digital camer ... Konica Revio KD-310Z Digital Camera

Konica kd-400z Hi, I have the Konica Digital Revio KD-400Z, The lens has stopped going in and out and is now stuck half out. It keeps coming up with system error s0042 and A00B, any ideas how i can get it working again or where i can take it?


... Konica Revio KD-400Z Digital Camera

Konica digital revio kd-310z


... Konica Revio KD-310Z Digital Camera

My camera lens wont close and says system error s0042 konica revio kd-310z


\012\012try these:-\012\012connect it to pc and on it\012vaccum the barrel of lens\012changing mem. card and batt. for 2min.\012 ... Konica Revio KD-310Z Digital Camera

System error s0041 - Konica Revio KD-310Z Digital Camera


HelloThe problem is that the lens has become stuck in the barrel\012 after dropping it. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\ ... Konica Revio KD-310Z Digital Camera

My konica revio kd 310z got an error and seems to have lost all pics except 4 - the error has now gone after a few weeks and still no pics - where did they go ???


Hi there,\012Well first of all you check both of the memory for pics, camera memory and the card (data card) memory.If the pics are not on both of the memory locations it means the pics are corrupted from the memory location, If you ... Konica Revio KD-310Z Digital Camera

Driver Konica Revio KD-310Z Digital Camera


... Konica Revio KD-310Z Digital Camera

System error SOO42 on KD-310Z - Konica Digital Cameras


... Konica Digital Cameras

I have the konica digital revio KD- 400Z and I can't close the camera in the screen said sytem error S0041 what is the problem ? I reading the manual but that not said nothing about please you can help me? thank you susana van t'Vlie [email protected]


I think the camera is defective Pls contact the Customer service Ph# 877-778-2687 ... Digital Cameras

I dropped my Sanyo SI070 VPC digital camera at a concert adn it warped the lense, showing me a 0X2110000 error on the screen , can it be fixed?


... Sanyo VPC-E7 Digital Camera

Usb cord Does anyone out there know where i can get a usb cord for a Konica Digital Revio KD-310z?


There are currently four of them on eBay ... Konica Revio KD-310Z Digital Camera

My camera tell my camera showes lense error - Konica Minolta DiMAGE G400 Digital Camera


\012\012try these:-\012\012connect it to pc and on it\012vaccum the barrel of lens\012changing mem. card and batt. for 2min.\012 ... Konica Minolta DiMAGE G400 Digital Camera

System error s0042 - Konica Minolta DiMAGE G600 Digital Camera


... Konica Minolta DiMAGE G600 Digital Camera

Nikon Coolpix P60 - Screen shows "Lens Error" Screen will not display any images / digital viewfinder will not display any images. Brand new camera, has never been dropped or damaged in any way. Fresh batteries, so it's not a battery issue either.


Same extact problem. anyone had luck getting theirs repaired and if you've taken it in how much did it cost? ... Digital Cameras

Lens error my camera keeps saying lens error and then shuts off My Kodak M753 digital camera is telling me "lens error: 1,1,5,1,0,0", how can I fix this? - I have no proof of when I bought it, so a refund is out of the question. my camera was covered by luggage and now when i turn it on, it says lens error I dropped my digital camera just recently back in October and all of a sudden when I turn the camera off the lens is still out when it's suppose to be in... I really don't know how that hap


This is probably THE most common failure among digital cameras. There's a halfway chance of fixing it yourself, described here: http://camerarepair.blogspot.com/2007/12/fixing-lens-error-on-digital-camera.html ... Fuji FinePix A345 Digital Camera

Need manual for konica revio kd-410z - Konica Revio KD-410Z Digital Camera


Hi,\015\012\015\012\015\012You can download the required manual by clicking the link below:\015\012\015\012 ... Konica Revio KD-410Z Digital Camera

My Canon is SD 1400is model. Recenly it dropped. Since then it shows E32 error message and then shut down later. I have to turn on the camera again. The focus seems okay but the message keeps showing up. Is there anyway to remove this error message?


Did you get a solution to this problem? ... Digital Cameras

System failure MF00C Konica Revio KD 420Z - Konica Revio KD-420Z Digital Camera


... Konica Revio KD-420Z Digital Camera

My wife dropped her Canon Powershot SD750 and we thought everything was OK. Then moments later when we tried to use it, the lens came out and then locked up and the screen showed 'lens error restart camera'. Since then, after numerous attempts to get camera to work, the camera still shows 'lens error' and the lens is always out and locked. Could you help?


HelloThank you for using FIXYA!!!This\012 is a suggestion. If you do not feel comfortable trying it, you will need to ... Canon PowerShot SD750 / IXUS 75 Digital Camera

Minolta G500 My camera lense wont close says system error S0042. Didnt drop it just open the lense to take a picture and green,red light started to flash on and off and then on the screen it said system error S0042


Your lens mechanism is stuck up! try pulling the lens with slight force, if you are lucky the culprit that is blocking the mechanism will get loose. If you are not lucky theres no way you can remove or fix the problem than sending it to the authorize ... Konica Minolta DiMAGE G500 Digital Camera

E18 error on canon digital camera s200 powershot dropped it and now the lens is stuck halfway out/in The lens will not open, it was not dropped. I get e18 error.


Canon Powershot's error E18 has to do with the lens: If it appears on a black LCD with E18 written on the corner, it is mostly due to the lens getting stuck while trying to extend. The camera will beep a few times and the LCD will display a lit ... Canon PowerShot S200 / IXUS 178 Digital Camera

Camera error hp photosmart 935 digital camera shows this error: stderr error 19 zoomzebu cpp rev 43 line 919 The lens does not zoom, the camera does nothing. I get the same. error 19 message on my camera. The solution given of pushing the middle button to right of screen while pushing the okay and V button.... I don't know what the V button is. I tried several different buttons with no luck.


Your lens is not communicating properly .It is stuck it is due to mechanically problem you are having this error. ... HP Photosmart 935 Digital Camera

Camera error hp photosmart 935 digital camera shows this error: stderr error 19 zoomzebu cpp rev 43 line 919 The lens does not zoom, the camera does nothing. The solution of pushing the middle button the okay button and theV button didn't help, because I don't know what the v button is. I tried pushing several random, and nothing worked.


That is a faulty zoom unit, unless it reset by removing the beatteries, this problem cannot be fixed with home repair.You need to contact HP, if they acknowledge this is a factory defect, you may be entitled to free replacement.See ... HP Photosmart 935 Digital Camera

Error message I have a panasonic DMC-LC33 digital. A system error message would show the minute I turned it on. The lens would come out. Then within 4 seconds the lens would go back in. I tried the on/off several time but the results were the same. I put the camera away for later. When I tried it the other day, it would not even turn on. The batteries are fully charged. Help!!!!!! I need my camera for my work. hi expert i m suffring in this error on my panasonic DMC-LC33 when i switched on


Try \015\012\015\012Klomtrix trick this worked with my camera\015\012thanks klomtrix ... Panasonic Lumix DMC-LC33 Digital Camera

Lens error i dropped the camera and it comes as lens error i tried to restart the camera but again it shows a message lens error i am really upset please give me a solution


Ur lens strip is broken change it or call me 9890274954 ... Canon PowerShot S410 / IXUS 430 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3973 seconds