Having problems with your Nikon D40x Digital Camera ?

Flash not automatically opening up.

\015 My d40x flash doesn't pop up like it did when i bought it. i have to open it manually and then it works. do i have it programmed wrong or something?\015

Answers :

Check the flash setting in the shooting mode (on Auto). Press the "?" button twice. You should see the flash mode window. Small box on the lower left for flash settings (hi-lighted in yellow, or navigate to it). Press OK to see and change flash settings to your preference.
Repair Help & Product Troubleshooting for Nikon D40x Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When do i use the flash pop up and when not. I was told that the camera would ask for this.Will it automatically go off in intel.auto or do i have to open the pop up. Do i leave this open and will it only go off when nedded Confused please help Thanks


It should work when you need it. Go in a dark room and try it. If it does not work then, you need to pop it out. Whenin doubt, use flash. It almost never hurts :>) ... Panasonic Lumix DMC-LZ2 Digital Camera

Flash not automatically opening up.


Check the flash setting in the shooting mode (on Auto). Press the "?" button twice. You should see the flash mode window. Small box on the lower left for flash settings (hi-lighted in yellow, or navigate to it). Press OK to see and change flash setti ... Nikon D40x Digital Camera

Hi, My D80 has suddenly developed a fault, where it registers the flash as open and in use even when its shut. This has the effect of syncing the shutter speed and limiting it to 1 200th in all modes. In addition, whilst the flash button will still change the flash mode using the command dials, it won't open the flash- almost like the camera thinks the flash is already open. I have tried prising open the flash, and it still doesn't fire even when open. There was no indication of a problem previ


Hi dave_lankest. My suggestion is to do a factory reset on the camera. This is found on page 129 of the manual. Open the rubber flap on the left side of the camera then you will see below the USB port a small button, that is the reset switch. If that ... Nikon D80 Digital Camera with 18-135mm Lens

Flash won't open on Canon Rebel XSi? It has been working fine but yesterday I went to take a picture and the flash wouldn't open. It won't open on any setting and it won't open if I push the manual flash button.


The openning flash button only works on non automatic shooting modes.On creative zone (automatic options with predefined options) the flash will rise automatically, based on the current exposure conditions. On "Flash Off" mode won't rise the fl ... Canon EOS Rebel XSi Digital Camera

I have a Panasonic DMC-TZ1 that I can't get the flash to go off on. The only flash setting that works on my camera is no flash setting and the icon for the no flash symbol appears white. The rest of the settings such as automatic flash with red-eye, and automatic flash, ect... are red. Is this a settings issues or a repair issue? If it is a repair issue could you tell me what on the camera needs to be repaired. Weather it be the LED light is broken or a resistor or transistor on the circuit


... Digital Cameras

Nikon D40X built in flash doesn't pop up automatically


This is a common fault with the D40x. You will need to contact Nikon for repair details. ... Nikon D40x Digital Camera

When I fit the radio transmitter module from a set of Jianisi PT-04TM wireless flash slaves to the FZ50 it will no longer select all settings of apeture and speed. With the camera on manual setting the apeture freezes on f4 and the fastest speed available is 1/250. radio transmitter wasn't allowing flash to open fully, as it projected out over flash popup. I tried fitting an extension to mount radio transmitter higher and allow flash to open fully but still the same problem Fitting a normal


I've looked through the PDF manual for this camera and found the flash system pretty well full auto with the built in flash here is the manual link I used it's the fifth one from the top.http://www.google.ca/#hl=en&biw=1303&bih=818&q=pana ... Panasonic Lumix DMC-FZ50K Digital Camera

The flash of my sx30 doesn't work, when i open the flash it was detected that the flash is open but the the problem is when i'm going to shoot even i press my shutter it doesn't take any picture and the flash sign in the screen just keep on blinking but no picture was taken. thank you!


Hion flash defuser unit up position, it doesn't allow to take picture. This means technically flash circuit is continuously sending charging signal causes blocking shutter release.( but not all of model, it is depend on model of camera.). Like thi ... Canon PowerShot SX30 IS Digital Camera

Flash does not open when I slide the "open flash" switch.


Yes, you could change it by yourself, but I strongly suggest to bring it to a technician.Here we go, gently lift the flash with the flash latch held open. It may have\015\012grit stopping it or a broken spring. Also make sure the latch is ... Kodak EasyShare DX7590 Digital Camera

Trouble in my camera: no flash while taking photographs even though it is set in flash position. As on opening there comes a blinking like'E:919'& flash symbol. It arose 2days back when I just opened to click a shot(press half the click botton).25 days ago I had faced the same problem & got repaired at SONY servicing center, Raipur. Just on the next use it problems again.What is the problem sir?


Flash capacitor doesn´t charge in a specific time. There may be more reasons. Camera remembers error state and do not use the flash even you turn it off and on. You can try to let it "forget" by resetting (initializing), but if problem persist, ... Sony Cyber-shot DSC-W55 Digital Camera

Flash repair hi, i am using olympus sp 570. my flash spring is not working. so when i try to open it . it will not open . i have to manually pull its cover to steady the flash.please tell me how to refit the sprig. regards nik


My Olympus SP-570uz also has a broken flash spring. I found that small a coil spring approximately 3/16" max diameter and approximately 7/8" to 1" long can be inserted in the flash cavity when it is open - place on the right side (looking at the fron ... Olympus SP-570UZ Digital Camera

Power issue Battery is charged, but camera will not power up. Lens is in open position as is flash. Charge light comes on and turns to green after some time charging so power is flowing? Camera is locked in the open position as in flash. Battery is fully charged. When I press the shuter button a little red light flickers for just a second.


Hi,   Basically this fault occure due to malfunctioning of zoom motor.And you have to replace the optical zoom lens complete assymbaly.  Or secondly just tell you the trick,Most of time it works and some time its not. ... Toshiba PDR-3310 Digital Camera

Flash does not open when I slide the "open flash" switch.


Try gently lifting the flash with the flash latch held open. It may have grit stopping it or a broken spring. Also make sure the latch is pulling right across to the right. ... Kodak EasyShare DX7590 Digital Camera

I have a Canon Powershot SD550 Digital Elph IXUS 750 and last sunday I shot some photos outdoor at the equestrin center, but when I went indoors I found I didn't have a flash operating either on automatic or on manual, and I thought they had a mechanism to prevent flashes so the horses wouldn't be spooked. Later I shot some photos on automatic and they came out but when we went inside the fash was inoperative. I haven't dropped or manipipulated the camera in any fashion. i sent the camera to the


Here are some simple things to try first for a camera that won't take a picture when the shutter button is pressed, or with an inoperative flash. They won't work for every case, but they're worth a try:\015\012 ... Canon Digital Cameras

My daughter drropped her coolpix s8000 camera. It landed on the corner near the flash and bent in a little. The flash would not open up. I had to bend ti back so the flash will now pop up. However, the flash does not work with a message that says the flash is not fully raised. Where is the senso for the flash being raised?


I had the same issue, droped camera then even if flash is opened the flash was no triggered. As Paul said I found the sensor for sensing the flash position, I made a few trials then I soldered one pin of the sensor to the sensor's case like in the pi ... Nikon COOLPIX S8000 Digital Camera

I have Sony DSC T2. I am facing some problem with flash. It only shows a single icon for flash (flash off). no other option appear when i touch on flash icon. it also blinks with E:93:1 at the middle of the screen and flash icon at the bottom when I open lens door. During this I don?t find any flash option (auto and timer). Would really appreciate if you could help me here.


Hi i had the same problem \012just go to HOME option \012then MAIN SETTING\012then click on the initialize option \012and reset the factory setting \012it resolve my problem \012hope it will solve your problem tooo ... Sony Cyber-shot DSC-T2 Digital Camera

I have a sony cybershot DSC-W210 and just recently the flash wont work when its on any mode to take a picture it has the flash symbol on the screen flashing and the code E:91:01 underneath also flashing its takin pictures as normal just without the flash it wont let me change the settings of the flash at all. Apart from this the camera lens shutter seems to be sticking when i turn on the camera it doesnt always open i have tried cleaning the lens but it doesnt seem to make any difference!


I have a sony cybershot DSC-W210 and just recently the flash wont work when its on any mode to take a picture it has the flash symbol on the screen flashing and the code E:91:01 underneath also flashing its takin pictures as normal just without the f ... Sony Cyber-shot DSC-W70 Digital Camera

I have a Vivitar Camera that I bought from a Pawn Shop. The Flash worked fine for the first few months having it. I didn't use it for a while, and once I finally did, I heard 3 pops. After that my flash no longer works. When I switch into Flash mode it blinks and goes back to No Flash mode. Do you think it's the flash tube, the circuit or the battery that charges the flash? I opened the camera and nothing looks blown.


The 8025 is a very cheap camera....I hope you didn't pay more than $15 at the pawn shop. Your camera has a blown flash tube. The camera could have been dropped in water by the previous owner. You could have bought one at Walmart that would have at le ... Vivitar ViviCam 8025 Digital Camera

Flash How do we manualy set the flash to stay on? in a lot of our pictures there are dark areas, if the flash was on this would not be happening.As far as I can see the flash is entirely automatic.


I assume you have a digimax D53 as this is where your question is posted. On the top of the camera is two black buttons and the silver button which is the shutter release. One of the black buttons, the one closest to the silver button, is marked with ... Samsung Digimax D53 Digital Camera

The problem is with the flash. When set on “auto” the flash will always go on during the day, when the conditions are great. I always have to set it to off. At night, no matter what settings I have, the camera on, the flash opens and sometimes it works, sometimes it doesn’t. No matter what I do, sometimes it just won’t flash.


Hi there ... Kodak EasyShare P850 Digital Camera

Kodak c613 flash is not working? I installed brand new batteries and the setting is for automatic flash but it will not flash. We have 2 of these cameras and the settings are the same, one will flash, the other will not.


Hi there if your right in your way then the problem occur on your camera flash. Its new so, still under warranty. So i suggest you visit the service center & ask for replacement. Thanks. ... Kodak EasyShare C613 Digital Camera

I am having problems with the flash working on my camera. It does not seem to matter if it is in automatic or manual modes. When I take a picture in either mode, when a flash is needed, the flash icon just blinks on the display. The camera will not take any photo when this is happening. The only way I can get my camera to take a photo is manually set the flash to off. Why is this happening?


Please reset camera through Reset option in Menu. This will set camera on default settings and any glitch in settings will be removed.Thanks. ... Canon PowerShot SD870 IS Digital Camera

White Screen Upon startup lens emerges but when screen appears it is white whereas it normally displays whatever the lens sees. When the shutter button is pressed the camera will focus and take a white picture which can be deleted. The camera does not flash although flash is set to automatic and photo taken in a dark room. Camera flashes (weakly) with flash set to manual on. Lens is unobstructed and appears to be perfectly normal. Camera was not dropped. Batteries have been changed.


\015\012Upon startup lens emerges but when screen appears it is white whereas it normally displays whatever the lens sees. When the shutter button is pressed the camera will focus and take a white pictur ... Pentax Optio E10 Digital Camera

Our 7 year old Kodak digital camera works as good as new. But the flash door will not open. We have a new battery and that has not helped. Can we open the door with out damage to the camera?


Hello Martha, Sounds like the spring mechanism that operates the flash lid has a spring problem, you can manually open the flash but it will not stay in the raised position without the spring unit working,it has nothing to do with the battery,it is a ... Kodak EasyShare DX7590 Digital Camera

My problem is the flash of my olympus fe-230 does not work even if it is in the automatics status. the red flash sign just pop up at the left side of the screen while capturing pictures. i already res


Have you tried to reset the camera back to factory defaults to see if it is maybe a setting that has the flash disabled? To reset the camera: go to Menu - left arrow to reset and press ok. Highlight yes and press ok. This will put the camera in f ... Olympus FE-230 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0943 seconds