Having problems with your Panasonic Lumix DMC-FX55K Digital Camera ?

When I turn on my Panasonic DMC-FX55 the lens comes out fine and the screen displays for 2 seconds then goes blank except for the message 'Turn off then on again' - which doesn't work. The only way to get the lens to retract is to select 'Playback' - tun off then on . The playback mode works fine and after 10 econds the lens returns to closed position. Is their a combination of buttons that reset the camera??

Answers :

Repair Help & Product Troubleshooting for Panasonic Lumix DMC-FX55K Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I turn on my Panasonic DMC-FX55 the lens comes out fine and the screen displays for 2 seconds then goes blank except for the message 'Turn off then on again' - which doesn't work. The only way to get the lens to retract is to select 'Playback' - tun off then on . The playback mode works fine and after 10 econds the lens returns to closed position. Is their a combination of buttons that reset the camera??

... Panasonic Lumix DMC-FX55K Digital Camera

When I turn on my Panasonic DMC-FX55 the lens comes out fine and the screen displays for 2 seconds but doesn't focus, it then goes blank except for the message 'Turn off then on again' - which doesn't work. The only way to get the lens to retract is to select 'Playback' - tun off then on, sometimes twice. The playback mode works fine.

HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\01 ... Panasonic Lumix DMC-FX55K Digital Camera

Lumix tz3 Please turn camera off and then on again" as soon as camera is switched on. I Can view any menu, or read SD card, but cannot take any pictures. If I turn on in a picture taking mode it starts to focus and then the message appears, when I turn it off the lens does not close. If I turn on in playback mode, it works fine, if I turn it off from playback mode, then the lens closes. Basically, any picture taking mode triggers the error message. Solution?

Low battery maybe? Try holding camera firmly in one hand, with camera on and in record mode, and strike in on its edge firmly on the heal of your other hand. This technique is often sucessful with temporary camer 'quirks' like freezing, lens not full ... Panasonic Lumix DMC-TZ3 Digital Camera

Camera was on, working fine. When powering off, telescoping lens did not retract so lens remained extended just a bit with lens cover open. Waited a few minutes, turned it back on and I get the "access" display message then the beeps and (turn power off and back on) message. While off, I have removed the battery, replacing it with a fully charged spare and it still does this. The lens tries to telescope a little bit and retracts a touch, but I can't get the camera out of this mode. Can it be res

Your problem may be due to corrosion on the battery contacts inside the camera\015\012which can prevent the full power of the batteries from flowing into the\015\012camera. Try this free fix before you do anything else: remove the batteries and wip ... Sony Cyber-shot DSC-W55 Digital Camera

I have a JVZ HDD camcorder and have suddenly found that the recorder is not working - when I turn it on the screen is staying blank - as if the lens cap were still on. I have tried resetting it but no difference. It worked fine last time and has not been dropped or anything in between. Note LCD works fine in playback mode

... JVC Digital Cameras

Displays all white in all modes. Kodak V570. Turn the power on and all I can see is white. I have tried a different battery an no battery, just power cord. I know the camera good enough I can go into the menu options and select some different features without actually seeing the menu. All that seems to work fine and the lens is working ok. I can push the shutter button, the flash goes off. I can't see the photo on the camera, but I can see the photo if I put the SD card into my computer. Please

Displays all white because all the color screen have RGB mode if any of mode's are not work correctlly it's mean's color chip was fail and not working. u have to repair ur camera and change ur display screen. ... Kodak EasyShare V570 Digital Camera

It turns on but won't take a picture when you push the button! I downloaded the pictures on the card because I was told maybe it wouldn't worked due to a full card. It did have 2300+ photos, but only 77 new ones, which downloaded just fine. I deleted the card and tried to take a picture in normal mode, but nothing happened. It doesn't work in ANY mode...not even movie! We have had trouble with the lens protector doors jamming, but that's not the problem now. They open, lens goes into position an

The shutter button has a little nib on its end that can break off with age. This tiny piece of plastic extension is needed to fully depress the shutter switch inside the camera. There's a fellow on ebay that sells these with instructions ( ... Canon PowerShot A520 Digital Camera

I have a Canon XM3 camcorder. It has given me many years of good service. Recently it has developed a fault. When I switch it onto Camera mode, and then flip the switch to Standby, the small screen flickers blue for a short time, but it does not show the image from the lens. If I switch off, and sitch to Playback, the small screen works OK and all the Playback works fine. Sometimes when I switch to Camera, and Standby, the small screen flickers blue, and then an image from the lens appears, but

Its the problem of CCD assembly\015\012CCD (image sensor) failures, particularly in conditions of high heat and humidity, led to cameras capturing images with either no picture at all, or with extreme distortion and se ... Digital Cameras

Power/lens Problems I'm having some power/lens problems with my camera. When I turn on the power in either the picture or video mode, the green light will turn on for a split second then turn off. The lens does not come out at all. However, when I try to turn it on with the picture viewer or in the menu it works just fine. When I start with the picture viewer and then switch to the camera it turns off. Thus it seems that whenever I want to take a picture or a movie the camera doesn't work.

It seems that the lense movement is jammed. Have you dropped the camera? just have a close look from the front side of the camera, does the lense assembly seems to be pressed or moved aside by some extra preassure? if no physical disalingment is vi ... Sony Cyber-Shot DSC-P72 Digital Camera

When I turn my SD400 digital elph on to cameral mode, it turns on for a moment then turns off, beeps 4x and shows a black LCD with the code E18 in the bottom left hand corner. Charging the battery has not resolved it. Playback mode works fine.

Connection is loose or beltstrip broken ... Canon PowerShot SD400 / IXUS 50 Digital Camera

Lens error I've had my camera for about 9 months and it's been working fine. 2 weeks ago I turned it on, went to take a photo and instead got this "Lens error" and the lens won't retract back in and the camera won't do anything. Sounds like this is a typical problem. Anything I can do to get my camera working again?

Try these procedures. ... Nikon Coolpix L11 Digital Camera

Zoom lens will not retract- camera turns on and off but nothing changes and it wont take pictures. When I turn it on the lens clicks but does not move. The camera keeps telling me to turn it on and off again but nothing different happens when I do. The battery is fully charged and it was working fine. Does it have a reset button? If so where?

Hi,This is a common Error. There is NO Reset Button. If under Warranty, send the Unit for Repair. Unless use the below techniques, if that could help.There is no point in Getting it Repaired by a tech it would cost you more than $100.If y ... Sony Cyber-shot DSC-W80 Digital Camera

Hi, I've just recieved my nikon d90 back from a repair and service, and although everything appears to be working fine, whenever I want to change shooting modes,( auto, P, M, flash off etc), they only work once I have selected them, and then turned the camera off and back on. In other words I cannot be shooting in the Auto mode and then switch to "flash off auto"....all that happens is that the auto focus works but the shutter will not operate. If I switch the camera off and on however, I can t

I'm going to assume at this point that the camera has been serviced correctly. What I'd suggest is that you look in your manual and find where you can reset your camera back to the factory default settings. Okay here are a few thoughts that might be ... Nikon D90 Digital Camera with 18-105mm lens

My canon camera Ixus 8515 has an error when turning on (after some 'stuck' noises) that reads 'lens error, restart camera'. The lens is not retracting. The camera has not been dropped. Was working fine one minute, then camera appeared out of focus the next. When I turned camera off then on again, error appeared. Lens won't go back in. Have not tried forcing it as yet.

HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you wi ... Canon Digital SD900 / IXUS 900 Ti Digital Camera

I have a Panasonic DMC-LX2 digital camera, I'm based in the UK. Has worked fine for a couple of years, but 2 weeks ago, when powered up, none of the buttons work. Screen is illuminated, lens emerges OK, mode-select dial still rotates and switches between modes, on/off switch and aspect switches OK, but shoot button, all 5 'menu group buttons, anti-shake button, display/LCD mode button, waste basket buttons', zoom in/out control and 4-way direction button all 100% non-functional. Card is being ac

I just got identical situation today, and I have no clue at all. However, I figure that the camera is actually working busy like someone is holding the "UP" button continuously. To see this, power on your camera at any mode except the "Scene mode". A ... Digital Cameras

When I turn my 550 PowerShot on, I get a blank screen (black for the most part with white camera symbology around the screen, such as the flash symbol, etc). The screen works, as I can click a picture and see the photo momentarily. I can also view my saved pics. When I select the film mode, the screen looks normal.......meaning it displays a color image of what is in the lens. Have I inadvertently selected a mode which is causing this phenomenon?

Think that you might have accidentally pressed the DISP or DISPLAY button on the back of your camera. This manually turns the LCD display on and off to save batteries. You would then use the optical viewfinder in its place. To turn the screen back on ... Canon PowerShot A550 Digital Camera

The batteries work fine but everytime i turn it on the camera the screen goes black and the lens retracts back into it! i can't figure out whats wrong and i know its not dead the batteries work fine like i said before.

I can't figure out whats wrong and i know its not dead the batteries work fine like i said before.\015\012Before you dismiss the option, do yourself a favor. It only cost under 20 dollars to buy a new set of rechargables and a charger ki ... Kodak EasyShare Z740 Digital Camera

My olympus stylus710 digital camera is currently not working. when we turn the camera on the lens opens and extends, quickly retracting. this happens several times before the unfocused screen turns blue and D: 5f08 5e02 comes up on the screen. once its in this mode no buttons work except just to power it down. any ideas on how this can be fixed? thanks

That looks like a software error. Check that the battery is fully charged and read the manual at troubleshooting section. if you don't have one, seach on web and you`ll find it. ... Olympus Stylus 710 Digital Camera

My canon powershot only powers on in playback mode. when i try to power up in camera or video mode, the camera's lens tries to retract but only for a split second and always returns . I have bo video or audio CAPTURE only turns on for playback.. I do not wish to purchiss another camere and Id like to use my 4 GIG

... Digital Cameras

A85 Dead During a normal session, switching from picture-taking mode to view mode, the lens would not retract and the picture in the view froze with the current image. I could not turn off the camera. After a while, the batteries got very hot, so I removed them. I took out the CF card. Later, I replaced the batteries and the put the card back in. The camera worked very briefly, but the LCD view would not work, displaying flashing lines on a black background. New batteries didn't help. The camera

I read something about the fuse going out...http://www.dcresource.com/forums/archive/index.php/t-18151.html ... Canon PowerShot A85 Digital Camera

I have a Kodak Easyshare model dx5430 digital camera (5mp). It has worked like a champ for years. Last night I was at an event when the image display went dark at picture 31. All preceding photos were able to be reviewed. The camera flash works fine. The camera displays all the other characteristics of a working unit. It turns on and off; the flash works, the menu is accessible - everything. It just doesn't register any photos. Even in close-up mode, there is nothing. It's as if the lens cap is

A stuck shutter is another common failure mode for digital cameras. The symptoms of a stuck or "sticky" shutter are very similar to CCD image sensor failure. The camera may take black pictures (for shutter stuck closed), or the pictures may be very ... Canon PowerShot A75 Digital Camera

My canon TX1 is about two years old. I recently went to use it and its not working properly. I can put it in play back mode manual mode or scn mode. As soon as I turn it to auto which I normally use the screen goes black and the power goes off although the lens does not retract. The battery is fully charged. Any suggestions?

... Canon PowerShot TX1 Digital Camera

Canon S2 when turning on in the shooting position...get message 'change battery'...rn when turning on in the 'view pictures' mode...camera works fine. Is the lens stuck?

WD-40 on a camera WOW ,,,,,ARE you ever lucky.. ... Canon PowerShot S2 IS Digital Camera

Frozen Camera The camera screen does not display the subject and when "Off" os selected the lens does not retact. Zooming in or out does not work. A photo can be taken but the result is usually very poor being out of focus and incorrectly exposed. I have tried removing the batteries and replacing them with new ones - same problem. Meus and playback work fine.

... BenQ DC C40 Digital Camera

Hi, I have a Ricoh Caplio R5 which appears to be working normally in all areas except that when you switch it on, in both camera and video mode, there is no image on the screen and if you make an exposure, it still makes all the correct noises etc but obviously there is no captured images. The lens etc motorises into the correct position and the lens cover retracts. I have been through and selected the default settings where possible, but I was wondering if there was something that should be

Are you able to use the screen while going over the cameras settings but noting when trying to take a picture etc? Or is the screen blank at all times?Have you tried hooking it to the tv to see if anything comes up? ... Ricoh Digital Cameras
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3744 seconds