Having problems with your Panasonic Lumix DMC-FX9 Digital Camera ?

Lumix FX9: Display says,"please turn camera off and then on again

\015 About 15 seconds after start up, the back screen reads "please turn camera off and then on again". It will take photos until that time, but taking photos does not change anything - after 15 seconds the message shows up and I have to shut it down. Battery good, wasn't dropped or overheated, nothing like this ever happened before. \015

Answers :

Hard to say, this is very rare on a camera, but if a Reset back to factory settings does not work, im afraid it will have to be replaced.
Try to reset it  as default settings...
Repair Help & Product Troubleshooting for Panasonic Lumix DMC-FX9 Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lumix FX9: Display says,"please turn camera off and then on again


Hard to say, this is very rare on a camera, but if a Reset back to factory settings does not work, im afraid it will have to be replaced. ... Panasonic Lumix DMC-FX9 Digital Camera

About a week ago I turned on my Lumix TZ5 and in the screen displayed this message: "please turn camera off and then on again. I have taken the battery off and I have charged, but the message still displays. When I turn the camera on, the lens extends to the maximum but when I try to use the zoom the camera doesn?t respond. Then if I turn it off the lens stays out. Any idea? Thanks in advance. P.


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\012\012\012\012\ ... Panasonic DMC-TZ5 Digital Camera

Purple Screen My camera turns on, but the display screen is purple. It flashes and snaps to take pictures, but the picture doesn't come out, only a purple screen. Please help. I have a new Panasonic Lumix DMC FZ28 camera and it seemed to have just died. I was taking a picture and it stopped, the screen turned purplish with thick lines. I tried turning it off and on, but it went dead. any ideas? it's 2 mos old


If it is only 2 months old,then you still have warranty.A purple lcd, viewfinder and photo is a 100% CCD failure.If out of warranty, not worth the repair. ... Panasonic Digital Cameras

When I turn on my Lumix DMC-FS3 Camera the lens tries to go out but it does it half way, then it goes in and the action is repeated about three times. Then there is a message on the display that says "Please turn off your camera and then turn it on again". I do that and the process repeats. Thank you.


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Panasonic Lumix DMC-FS3 Digital Camera

Hi I have panasonic Lumix DMC-FZ20 and when I start camera on the display it come with message "plz turn camera off and then on again." But it dont really do anything when restart occurs. It keep showing same message. Although it allow me to see old pics when started with play mode but dont start if the message has already on display. Moreover, when this message is on it wont allow me to work with any of the camera function including zoom in/out. . . Many Thanks . . .


Usually when this message pops up it indicates the lens position is jammed, you will need a camera technician to assess the item for repair cost. ... Panasonic Lumix DMC-FZ20 Digital Camera

My Panasonic Lumix DMC-TZ2 camera has a blurred display within 25 seconds of being turned on when in any mode other than playback. When the display blurs, it quite quickly becomes unviewable, and if I try to take a photo, an error message saying WRITE ERROR PLEASE CHECK THE CARD shows on the screen. The card seems fine and pictures I took before today all look good, both on the display and in a computer. Is there any fix, or do I need a new camera?


This is a problem with the camera lens and yes this can still be fix but you need to have it check on a service center but that price will not be cheap so if I may suggest it will be better to get a new camera..... ... Panasonic Lumix DMC-TZ2 Digital Camera

I have a panasonic lumix camera model DMC-FZ28. I flew to India two days back and when i arrvied I turned it on to take a photo. the display was very blurry and the camera was emitting a loud whirring noise. i have just turned itt on now and the camera is still making a whirring noise but it is more feint. what could it be?


HelloThe problem is that the lens has become stuck in the barrel\012 after dropping it. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\ ... Digital Cameras

My panasonic lumix dmc-lz7 camera is not functioning. It turns on the zoom goes in and out and then displays the message "please turn camera off and on again" after doing this the zoom stays out. Turning it on and off again does not get it to work. Jessica


Battery might be weak and needs a replacement or there is improper shutting down. ... Panasonic Lumix DMC-LZ7 Digital Camera

I have a Lumix DMC-LZ10 camera. When I turn it on the lens zooms in and out over and over and then asks me to turn of the camera and restart. I can not take pictures at all. The LCD does display but it will not function properly.


This message appears when force has been applied to the lens. You may need service. ... Digital Cameras

Lumix DMC-F3 When I turn the camera on, the display screen says "PLEASE TURN CAMERA OFF AND THEN ON AGAIN" when you do it, it says it again???


There is a problem with your camera Lens Assembly. It is not opening within stipulated time. The lens assy is jammed or damaged. Take it to service center. ... Panasonic Lumix DMC-LZ2 Digital Camera

When I turn on the camera (Lumix DMC-FX35) the lens goes in and out a few times and then displays a message telling me to Please turn camera off and then on again I have done this several times and the lens problems persists What should I do?


... Panasonic Lumix DMC-FX35S Digital Camera

My panasonic lumix DMC-ZS1 has "Zoom Error". How would I fix this? Witin 30 seconds of turning the camera on it displays ZOom Error ,and nothing will work. You just have to turn the camera off.


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \015\012probability is that you will have to get it fixed by ... Panasonic Lumix DMC-FZ28 Digital Camera

My Panasonic Lumix FZ8 has a problem with it's LCD Display. If I use the ViewFinder everything is OK,but when I turn ON the LCD,the camera turns OFF. What is the problem?


If the battery is low it will do this. It requires more battery to operate the lcd than the viewfinder. Also, check to see if the power save mode is on. ... Panasonic Lumix DMC-FZ8 Digital Camera

My digital camera, Panasonic Lumix DMC-LZ2 has the lens stuck. The display says "Please turn camera off and then on again" I tried blowing compressed air around the lens already.


Hi,\015\012\015\012I had the same problem with the same camera, and i also tried compressed air but it doesnt work,\015\012\015\012Finally I left the camera upside down for about 5 hours and it magically came back to life..Try ... Panasonic Lumix DMC-LZ2 Digital Camera

Hallo, when I turn on my Lumix DMC-LZ2 the display is black, and the image appear only if I press or twist strongly the camera. In the review mode the stored pictures appear on the display without problems. Thank you.


HelloThe problem is that the lens has become stuck in the barrel\012 after dropping it. There are some DIY solutions you could try, but the \012probability is that you will have to get it fixed by a professional.Use\012\ ... Panasonic Lumix DMC-LZ2 Digital Camera

After a little shock the camera still works, but: turns the pictures in a confused way, one is upsite down, the next on the left and so on. This would not be a big problem, but: after a short time the display ask for switch off and then to switch on the camera. What can I do to use my Lumix DMC-FX100 more comfortable? Thank you, E.B.


Does it flash any error code on the camera before/after it asks you to turn off? ... Panasonic Lumix DMC-LZ2 Digital Camera

I selected open folder to view pictures. The f: file display DCIM. I clicked it and it display Olympus displaying pics. I name a couple of pics in the slide. I wanted to change the folder name I went hit delete. I turned the camera off and then turned it back on. I turned camera back on thinking (how dumb) I restart process again. DCIM displayed. I renamed it "Digital Camera". It display Olympus. I clicked on Olympus renamed Holiday 2009. Then clicked on it - it says this


It sounds like you deleted the images. If you are downloading images from your camera or card....you should open the folder to view images. hold control key down and select all images that you want to download. right click on them on click save. ... Olympus D-595 Zoom Digital Camera

My camera problem is :when i start or turn on the power button of camera a massage is displayed which is "Turn off the power and on again " i followed the same but again when i am turning the power on again ,same massage is being displayed in camera . camera model is :SONY DSC-W180 cyber shot please help me out soon.


HelloThe problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the \012probability is that ... Sony Cyber-shot DSC-W180 Digital Camera

My samsung s1070 will not turn on. it was working yesterday and i was able to take pictures with it. now when i turn on the power button the camera beeps three times but nothing is visisble on the lcd display. also the lense is fully out even though the camera will not turn on. why is this happening and can you please advise me how i can turn the camera back on so that the display works aswell?


OK you are probably going to think I am loony giving you this advise But No I am completely sane!Get a can of compressed air OR acces to a compressor at your local garage Get them to fit the triggered air blower tool to it.Blo ... Samsung S1070 Digital Camera

How do i fix the system error (focus) message on my lumix zs1. the lens wont retract when shut off, either. can't focus nor take photos, and the camera displays a message to turn it off and then back on again


Fixing a Lens Error on a Digital Camera\012\012This has to be THE most common failure mode for a digi ... Panasonic DMC-ZS1 Digital Camera

Hello, I have a Lumix Panasonic DMC-FX9 and I turned it on today and the screen reads "THIS MEMORY CARD IS PROTECTED" I cannot take pictures nor can I change the screen. It seems to be locked. Though I didn't lock it but I do have a 3 year old who may have touched the camera. Any help would be much appreciated! Thanks in advance, Christine


Take a look at the memory card. SD cards have a slide switch along one edge. The position farthest from the contacts locks the card, protecting it from writes. The position nearest the contacts unlocks the card. If the switch is already in the proper ... Digital Cameras

My panasonic lumix dmc-fx01 has stopped working, When I turn it on, the viewing screen comes on, I see screen and menus, but the scrolling button doesn't work to select, the zoom doesn't work and shoot button doesn't work. When I have camera in play mode and in video mode the screen displays this message: memory card error please check card This happened before, I took it to be repaired and it cost 90 euro to have a bit of dust removed


Navigate to this page ..>Panasonic Lumix Dmc-Fx01 service manual and go to page #20 Disassembly and Assembly ... Panasonic Digital Cameras

Display break - Panasonic Lumix DMC-FX9 Digital Camera


Change it ... ... Panasonic Lumix DMC-FX9 Digital Camera

Display problem Hello, I've had my SD1000 for less than 3 months. Sometimes the display goes black, I can still access the menu options and if I slide the button to review images they will display on the LCD panel. But even if I've just powered it on, the LCD is black, if I take a picture anyway, the picture is also black. Sometimes if I turn on the camera and turn it off again a few times it starts displaying correctly again. Is there a hardware problem with my camera or is this something I sho


I had the same problem with my SD1000 and was so frustrated with reading all of the troubleshooting "solutions".... After a couple of days researching, I finally stumbled upon a site that actually suggested turning the unit off and "slapping" it a c ... Canon PowerShot SD1000 Digital Camera

There are several problems with my camera one of them is the fact in that Every time i turn on my Lumix 10x mega pixel camera the lens won't focus it also won't let me take any pictures. When i turn the camera off the lens won't go back into the camera but when i turn it back on the lens gos in and then out again. There is one more problem whenever i go to look at the pictures on play i can look through a few before its says "please turn camera off then on a again" it also says the same message


OK, if there is sand in the camera, the gears will bind or stop causing the error that you described. I think it needs to be taken apart and cleaned by a service center before using again. Or you could buy a spare caemera to use on your family holida ... Digital Cameras
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4113 seconds