Having problems with your Panasonic Lumix DMC-TZ3 Digital Camera ?

My Panasonic DMC-TZ3 in any shooting mode produces the following both on the screen and in a captured image: a blurry, snowy, magenta-tinted (visual noise?) presentation. At one point, it produced several normal images, then returned to the problem. The playback mode produces normal images from sored normal images. I have never dropped the camera or exposed it to high heat or cold. I have 3 batteries and none produce any variance in the bad image. I've tied all settings and reset. Up until the


Answers :

The problem you have mentioned is definitely a case of image sensor malfunction since the distortions are appearing in the pictures too. Getting the imagesensor replaced is the only way to fix this problem.
Hi,
\015\012Just tap on the sides of camera when you switch on it . There is definitely a loose contact between the screen and circuit board inside it . You confirm it to check that you are facing this problem due to bad connector . If you still face dark screen then it is due to faulty CCD sensor . You need to replce it ,but it will cost you alot in repairing it .\015\012
\015\012Hope this helps.
\015\012
\015\012Shane
\015\012
Repair Help & Product Troubleshooting for Panasonic Lumix DMC-TZ3 Digital Camera

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Panasonic DMC-TZ3 in any shooting mode produces the following both on the screen and in a captured image: a blurry, snowy, magenta-tinted (visual noise?) presentation. At one point, it produced several normal images, then returned to the problem. The playback mode produces normal images from sored normal images. I have never dropped the camera or exposed it to high heat or cold. I have 3 batteries and none produce any variance in the bad image. I've tied all settings and reset. Up until the


The problem you have mentioned is definitely a case of image sensor malfunction since the distortions are appearing in the pictures too. Getting the imagesensor replaced is the only way to fix this problem. ... Panasonic Lumix DMC-TZ3 Digital Camera

White out Every photo I take seems to white out, as if it is letting in to much light. But it is more than this, as it is possible to see white streaking on the image as well. I have also tried taking photos in various manual settings, resulting in the same problem. It seems to be a little better in doors. However when I use video mode the image is normal. This problem first occured on holiday in Singapore - when I took it into a shop out there they said it was probably the heat. But the problem


There was a known problem with a batch of early F710s that came out of Japan - I managed to get mine sent back for a free repair... but that was four years ago. Unless it's still under warranty not sure what you can do. ... Fuji FinePix F710 Digital Camera

I have a nikon d200. The last time I used it (only a few days ago) it was fine, everything normal. Then yesterday I pull out out of the case and everything seems to be going wrong. It is metering INSANELY low, like a shutter speed of 100 in full daylight produces a REALLY dark image. It won't auto focus at all, and i am unable to change the fstop in manual or aperture priority modes. I tried to restore it to factory settings and the lcd screen flashed to indicate it had been restored but no luck


Your boyfriend is probably right, and it makes sense, if you can't change the f-stops. \015\012The following blog on Flickr might help you:\015\012 ... Nikon D200 Body Only Digital Camera

Horizontal Lines I found in my Canon PowerShot S 500, in the screen, the image appearing having horizontal lines in it, in the replay after imaging and replay mode, and after it is on the computer, the lines appear in the picture clearly pixelating the picture horizontaly, while in video mode, no lines appear at all while videoing and viewing the video. in the viewing mode normally before taking the picture, i found that there is very light lines cannot be seen easily, but became clear when i tr


Even am facing the same problem is it due to the problem mentioned in this site?\015\012\015\012http://www.canon-asia.com/index.jsp?fuseaction=image-phenomena_notice ... Canon PowerShot S500 IXUS 500 Digital Camera

I own a canon powershot S3 is and I am getting this strange E24 error where in the camera lense would comes out and just goes in . Another interesting thing I observed is when the LCD is on and I am in the image display mode (That is browsing the existing images) then there is no problem if the LCD panel is open or closed the camera just seem to respond normally, only when I change to the shooting mode the camera lense would come out and go in with the camera shutting down. what is problem with


It sounds like it needs to be serviced. If you're out of warranty, then go to this site: www.camerasandparts.com They just service the Canon Powershots exclusively and they ... Canon PowerShot S3 IS Digital Camera

My Canon SI/IS Power Shot digital camera is not able to bring up image on normal operating picture modes. It does however still show stored pictures when I change back to images already stored in camera. In picture mode all I get is a dark screen and lines. What's up?


Definitely sounds like you have a bad CCD. The good news is, this camera is under recall for that exact issue. Canon will repair your camera OR possibly replace it with an S5IS even! Free of charge of course.From Canon website: " ... Digital Cameras

I have a Carl Zeiss Optical 3x Sony Cybershot. When I flip it open to turn it on, the image is either moving with horizontal lines, or blurred vertically (image looks like it's melting). The photo images come out as they appear on the camera screen. Sometimes the image will appear clear and normal on the camera screen when I flip it open. The camera hasn't been in intense heat or cold.


Hi,It seems some thing thing wrong with CCD Imager or its connections with main board of camera.Let me know exact model number of Sony camera as it would be written at bottom, to provide you solution. Also let me know are you ready to apa ... Digital Cameras

I have a Sony DSC-F88 5.1MP camera... When you switch it on to any of the program modes - image dispalyed on LCD and photographed is distorted. Image is skewed with the edges of the image flaring with three colours to the edge. A kind of focus shift..low resolution image - sort of semi solarised picture. Any previous picture taken displays normal on the LCD... I have tried other memory sticks.. no change..


Your DSC-F88 has problem with CCD Imager and needs to be replaced. Good news is Sony will replace it free of cost. Click Sony Official ... Digital Cameras

Canon Powershot G10 image quality problems... I have had my Canon Powershot G10 for 2 years and have had the same problem from the start... it is now driving me mad! When viewing photos in anything other than the supplied Canon Zoom Browser or Photo Professional the quality is poor. The images are noticeably blurred and appear grainy. I normally shot in manual mode with ISO80 and record images in RAW+JPEG. Processing the RAW photos seems to slightly improve the blur (though it is still there)


... Canon PowerShot G10 Digital Camera

I have just bought a Lumix FZ18 camera (July 08). It worked perfectly on all settings at first, but has now developed an apparent fault in which it shows an overexposed image on all settings apart from automatic. When the shutter button is partially depressed, the image in the viewfinder or on the screen shows as normal, but when the shutter is activated it immediately reverts to over-exposed and the resulting image is the same. Can you advise please


Fix #1: Remove the batteries from the camera, wait a few minutes. Put a fresh set of batteries back in (preferably rechargeable NiMH 2500mah or better) and turn the camera on. Fix #2: Remove the bat ... Panasonic Digital Cameras

Please help! I have a Canon Powershot A460. When I take pictures in macro mode, they are all flashed out, so bright even if taken indoor. I can barely make out an image. But if I take normal shot, results seem normal. I have read the manual -basic & advanced- but I can't find the right solution. This does not happen before.


Try going into the M(anual) mode on the selector dial and then turn off the flash (press the right side of the controller button until you see the lightning bolt with a bar through it). The macro shooting option should still be available in the manua ... Canon PowerShot A460 Digital Camera

"overexposure" The problem arose after I visited a botanical garden and went from cold outside weather to high temperature and humidity conditions. The next day I found that the image through the viewfinder and lens appeared vastly overexposed, nearly all white. If I focused on an object, the exposure would return to normal, but the picture taken was shot through all over with fine white lines, making it indecipherable. The exposure through the lens and viewfinder has now returned to normal, but


CCD failure. Known issue apparently based on other posts on other forums and web sites: http://www.nikon.co.nz/pagearticle.php?pageid=2-bdc691bf61 ... Nikon Coolpix 5700 Digital Camera

My camera produces colored flashed, stripes too, not only on the screen, also on the images. It is not equal at all modes. Sometimes it is frequent in the "automatic" mode and if I chanche to "P" it is less. But it happens now more frequently. Is there something to do against it? what will cost the repair?


... Canon PowerShot G9 Digital Camera

A85 Dead During a normal session, switching from picture-taking mode to view mode, the lens would not retract and the picture in the view froze with the current image. I could not turn off the camera. After a while, the batteries got very hot, so I removed them. I took out the CF card. Later, I replaced the batteries and the put the card back in. The camera worked very briefly, but the LCD view would not work, displaying flashing lines on a black background. New batteries didn't help. The camera


I read something about the fuse going out...http://www.dcresource.com/forums/archive/index.php/t-18151.html ... Canon PowerShot A85 Digital Camera

Light Meter When I am in manual mode, my light meter seems to be off, especially when I am in the sun. When I adjust the settings to even out the meter, my pictures always come out over exposed. I have to compensate by making them "under exposed" so that they come out normal. Does anyone know what the problem might be?


Check your metering settings. Are you using centerweighted, matrix, or spot metering? Try setting camera to matrix metering, use program mode 'P' and adjust exposure to default. ... Nikon D50 Digital Camera

Hi, I have a Ricoh Caplio R5 which appears to be working normally in all areas except that when you switch it on, in both camera and video mode, there is no image on the screen and if you make an exposure, it still makes all the correct noises etc but obviously there is no captured images. The lens etc motorises into the correct position and the lens cover retracts. I have been through and selected the default settings where possible, but I was wondering if there was something that should be


Are you able to use the screen while going over the cameras settings but noting when trying to take a picture etc? Or is the screen blank at all times?Have you tried hooking it to the tv to see if anything comes up? ... Ricoh Digital Cameras

Black images I take a picture in auto mode; everything appears to work normally and the image is black


I think the shutter broken.Your problem is same me.And now i need some disassembly procedure for replace it by my self.\015\012\015\012The technician send, you can disassembly it from front of camera not from back to CMOS. I o ... Canon Digital Rebel / EOS-300D Digital Camera with EF-S 18-55mm Lens

When I turn my 550 PowerShot on, I get a blank screen (black for the most part with white camera symbology around the screen, such as the flash symbol, etc). The screen works, as I can click a picture and see the photo momentarily. I can also view my saved pics. When I select the film mode, the screen looks normal.......meaning it displays a color image of what is in the lens. Have I inadvertently selected a mode which is causing this phenomenon?


Think that you might have accidentally pressed the DISP or DISPLAY button on the back of your camera. This manually turns the LCD display on and off to save batteries. You would then use the optical viewfinder in its place. To turn the screen back on ... Canon PowerShot A550 Digital Camera

Program mode I have a question about the program mode. there are 4 choices according to the manual: 1. Normal, 2-High-peed priority, 3-Depth-of-field priority, 4-MTF priority. I know I am going to feel stupid, but what is MTF priority? I wasn't any good at acronyms in the service either.


MTF = Modular Transfer Function. MTF tests is a chart describing the lens performance (sharpness, contrast etc.) throughout the aperture range. All lenses has a "sweet spot", where the best performance is given. But this can vary, not just from lens ... Pentax *ist D Digital Camera

Hi, im getting an overexposed effect on my still shots.. almost a whiteout and then i may get a normal exposed image with a subsequent shot all my settings are on auto.. my video recordings are normal. whats my prob?


Hi\015\012\015\012best place to start with would be t reset the settings to factory defaults\015\012\015\012this will set any high exposure, shutter, aparture settings that have stayed back to normal \015\012\015\0 ... HP Photosmart M525 Digital Camera

Canon has announced a problem with some of the CCDs used in its digital cameras and camcorders which causes images not to appear or appear distorted. This is due to a malfunction that means the wiring in the CCDs may come undone if exposed to high temperature or high humidity. The affected cameras are the PowerShot A60, PowerShot A70, PowerShot A75, PowerShot A300, PowerShot A310, Digital IXUS V3, Digital IXUS II, Digital IXUS IIs. Canon advises anyone experiencing these problems to contact them


Oh it's more than just the cameras you list, and also includes some video cameras.\015\012\015\012Canon will fix these for you for free if they're experiencing symptoms of CCD failure (black, lined, discolored, or distorted images). This ... Canon PowerShot A70 Digital Camera

High shutter speed causes band of over exposed image


I would suggest to check the lens inside. there might be some kind of small item inserted inside.check if this happens with no zoom and full zoom.if the problem persists, I would suggest to first have it checked with another lens just to ... Canon EOS-10D Digital Camera

There are vertical lines in the LCD in camera mode as well as pictures attempted with that display, but previous images already on the card display normally.


It looks like the ccd defectived. Try to contact Canon for free repair.\015\012 ... Canon PowerShot A75 Digital Camera

Z1275 produces horizontal lines through images. Flash, auto, program....doesn't matter what mode.


HiIf your Z1275 has horizontal lines going through the images you should call Kodak Technical servicethe number is 18002356325 op1 op12 op2thankshope this helpByron ... Kodak EasyShare Z1275 Digital Camera

Pictures are showing a pink glow over whole shot. Camera has always had great pictures, has not been dropped, or exposed to high heat. thanks...


This sounds like it might be a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. ... Canon PowerShot A80 Digital Camera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.lionebra.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1295 seconds